A fast-running method for blast load prediction shielding by a protective barrier

This study presents a simplified blast load prediction method on structures behind a protective barrier. The proposed method is basically an empirical approach based on Kingery-Bulamsh (K-B) chart and finite element (FE) analysis results. To this end, this study divides the structure into three regions by three critical points. Blast loads at each critical point can be calculated based on K-B chart and an approximation according to FE analysis results. Finally, peak reflected overpressure and impulse distributed on the structure can be approximately estimated by linearly connecting blast loads at each critical point. In order to confirm a feasibility of the proposed method, a series of numerical simulations were carried out. The simulation results were compared with FE analysis results which are presented in the open literature. From such comparisons, it was found that the proposed method is applicable to predict blast loads on structures behind a protective barrier.     

Experimental study of transient pressure wave in the behind armor blunt trauma induced by different rifle bullets

Pressure wave plays an important role in the occurrence of behind armor blunt trauma (BABT), and ballistic gelatin is widely used as a surrogate of biological tissue in the research of BABT. Comparison of pressure wave in the gelatin behind armor for different rifle bullets is lacking. The aim of this study was to observe dynamic changes in pressure wave induced by ballistic blunt impact on the armored gelatin block and to compare the effects of bullet type on the parameters of the transient pressure wave. The gelatin blocks protected with National Institute of Justice (NIJ) class III bulletproof armor were shot by three types of rifle bullet with the same level of impact energy. The transient pressure signals at five locations were recorded with pressure sensors and three parameters (maximum pressure, maximum pressure impulse, and the duration of the first positive phase) were determined and discussed. The results indicated that the waveform and the twin peak of transient pressure wave were not related to the bullet type. However, the values of pressure wave’s parameters were significantly affected by bullet type. Additionally, the attenuation of pressure amplitude followed the similar law for the three ammunitions. These findings may be helpful to get some insight in the BABT and improve the structure design of bullet.     

浅海舰船地震波场仿真中的边界处理

为解决舰船地震波场数值仿真中的边界反射问题,结合浅海传播环境特征和舰船地震波激发机理,提出边界处理算法。采用交错网格有限差分法对一阶速度-应力方程进行数值离散;采用应力镜像法处理海水和空气的自由表面,采用分裂式完全匹配层法处理区域边界;将该模型应用于平行海底近场、远场以及倾斜海底的波场仿真算例中。仿真结果表明:加入边界处理后,自由表面的吸收和区域边界的反射有效减少,波场特征清晰,该算法符合浅海舰船地震波场数值仿真的边界处理要求。     

超短波电台网模型研究

超短波通信是军事通信中广泛应用的通信方式,如何根据应用需要建立适合的网络与通信模型是作战建模与仿真中经常遇到和需要解决的问题。分析了当前超短波通信建模研究的现状,在详细探讨建模需求的基础上,提出了超短波电台网网络模型,给出了有效通信距离简化模型,以及考虑战场电磁环境和地理环境的通信链路质量模型,最后进行了仿真实验验证。该模型能够有效解决作战模拟中超短波通信效果对于作战效能影响分析的问题,简化了模型设计,提高了模型应用性,也为短波、微波、卫星等其他类型网络模型设计提供了参考建模方法。     

高超声速尖双锥流动高精度数值模拟

以25°/55°尖双锥外形的高超声速低焓层流流动模拟为例,对高阶加权紧致非线性格式模拟激波/边界层干扰流动的能力进行验证和确认。空间离散采用二阶MUSCL和三阶、五阶加权紧致非线性格式,时间离散采用二阶精度双时间步方法,通量函数采用混合Roe-Rusanov,AUSMPW+,Van Leer等,对比了不同精度空间离散格式对时间、网格收敛特性和通量函数耗散特性的影响。数值模拟结果表明采用高精度空间离散格式能在较疏的网格上获得收敛解,并能消除结果对通量函数的敏感性,但收敛需要推进更久的计算时间。数值模拟结果与实验测量结果吻合良好,满足工程精度要求。     

基于MIMO技术的山体滑坡雷达

现有山体滑坡雷达是轨道式的,这样就需要精确控制雷达的运动来获得高方位向分辨率,因此,硬件设备要求极高。利用多输入多输出(MIMO)技术通过分时发射和接收信号来获取高方位向分辨率,可以免去雷达运动,从而简化了雷达设备和降低雷达成本。此外,结合步进频连续波技术可以使山体滑坡雷达保持高距离向分辨率的同时进一步降低对硬件的要求,更易于工程实现,成本更低。通过MATLAB仿真初步验证了该方案的可行性。     

平底气泡船凹槽气层波动特性

为提高大型平底气泡船底部凹槽设计的有效性,基于RANS方程及VOF两相流模型构建了大型平板船凹槽气层数值计算模型。研究气层在凹槽中的动态发展过程,分析速度对气层波动的影响规律,并阐述三维凹槽气层的波形特性及其与二维气层波动的区别,揭示气层波动的相似律。数值结果表明:气层在凹槽中呈现波动形态,气层波长随速度的增加而增大,波长等于速度平方的0.64倍;气层在凹槽侧壁的干扰及反射下呈现相干波系,从而其波高及局部厚度也随之改变;气层波动满足傅汝德相似。     

基于空域相关滤波的雷达回波信号降噪方法

对雷达探测来说,如何有效地增强真实目标回波信号、提高信噪比水平是非常重要的。传统的降噪方法如平滑滤波、傅立叶降噪很难有效地降低与目标频谱相重叠的噪声。空域相关滤波算法是小波滤波算法中的一种,能够有效地解决这个问题。该算法是利用真实信号与噪声在尺度间的不同表现来实现的,能够在保留信号细节的同时,有效地降低噪声。仿真表明,该算法在雷达回波的降噪中取得了较好效果,有效地降低了噪声。     

实测海浪水压场特性分析

海浪水压场是舰船水压场的主要背景干扰.为深入研究海浪水压场与舰船水压场的特征区别,在大量实测海浪水压场数据的基础上,对其时域及频域特性进行研究,并对海浪水压场的平稳性进行了检验,结果表明,海浪水压场能量主要集中在低频范围,且随着海况和水深的增加,最大能谱频率向低频方向移动,在较短的时间内,可将海浪水压场视为平稳随机过程.     

基于LUT的射频预失真技术

分析了当前文献中几种主要的预失真结构,发现这些预失真结构均不适用于多通道宽频带短波通信中高功率放大器的线性化.提出了一种新的数字射频预失真方案,该方案能够完全适应短波宽频通信的高精度、多通道、宽频带的要求,而且不需要使用射频非线性有源器件.仿真结果表明,在短波通信系统采用这种方案,可以在很大程度上改善功率放大器的线性度.