大口径机枪弹性枪架稳定性分析的冲量法

大口径机枪在弹性枪架上射击稳定性的问题,是影响连发射击精度的一个重要问题,按传统方法以最大后座力或自动机后座到位的瞬间作用校核稳定性,其结果与实际射击现象不符。本文在分析大量实验现象后,提出稳定性分析计算中的冲量法,并以12.7mm 大口径机枪为例进行检验,结果与实验现象相符.     

内燃机噪声控制的现状与发展

军用装备动力设备噪声过大严重影响指战员的通讯,对身心会造成严重的伤害.介绍了内燃机噪声控制技术的发展过程和最新技术,对隔声罩的设计作了较为详细的阐述.针对军用装备动力设备噪声过大的问题,提出采用隔声罩是较为行之有效的处理方法.     

地下储油复杂组合空间油气扩散蔓延三维数值模拟

针对地下储油复杂组合空间,采用大涡模拟的方法构建了油气扩散蔓延三维数值模拟模型,完成了油气扩散蔓延区域的空间离散和三维数值模拟求解优化,并进行了数值计算与分析。结果表明,在地下复杂组合受限空间油料泄漏后,罐室内的油气填充顺序为由边缘到出口、由底部到上部,油气不能达到100%的充满状态,罐室拱形顶部油气体积分数低于其爆炸下限的20%;罐室内油气的产生和蔓延十分迅速,从泄漏至到达罐室口仅需10 s,进入坑道仅需1 min;油气在流出罐室进入坑道后,具有迅速向四周扩散蔓延,流向一切可能注入的空间的特性。研究结果为地下储油工程的施工建设、安全管理、危险源监控等提供了有益参考。     

装甲车新型大视场高潜望镜的研制

从设计角度论述了装甲车新型大视场高潜望镜的研制过程,重点分析了光学系统设计和结构设计。     

羰基化合物亚甲基化方法的研究

Takai试剂（CH2I2-Zn-TiCl4）作为亚甲基化试剂能高效地使羰基亚甲基化,这一方法与运用Wittig试剂等方法相比,反应条件更加温和、副产物更少、合成成本较低且收率高。     

The investigation of NTO/HMX-based plastic-bonded explosives and its safety performance

3-nitro-1,2,4-triazol-5-one (NTO) is the main component of insensitive munitions (IM) formulation because of its outstanding insensitive properties.In this paper,a series of NTO/HMX-based composite explosives were prepared and characterized.The study focuses on the effect of NTO on the performance of the formulations,especially the safety performance.The results revealed that the mechanical sensi-tivity of formulations was associated with NTO content,as well as the thermal conductivity,specific heat capacity and Arrhenius parameters.Then,the high amount of NTO using in formulation was proved to be helpful for NTO/HMX-based formulation to exhibit good thermal safety.Besides,by accelerating rate calorimeter (ARC) and a modified cook-offequipment,the pressure and pressure rise rate were proved as the important indicator for judging the thermal safety performance in confined spaces.Finally,the numerical simulation was used as a credible method for predicting the respond temperature of cook-off experiment.     

某型导弹并联挂架维修性试验方法研究

结合维修性试验的一般要求和方法,充分考虑新研设备维修性试验中遇到的具体问题,提出了某型导弹并联挂架维修性试验方法。     

Hazard evaluation of ignition sensitivity and explosion severity for three typical MH2 (M＝Mg,Ti, Zr) of energetic materials

MgH2, TiH2, and ZrH2 are three typical metal hydrides that have been gradually applied to composite explosives and propellants as additives in recent years. To evaluate ignition sensitivity and explosion severity, the Hartmann device and spherical pressure vessel were used to test ignition energy and ex-plosion pressure, respectively. The results showed that the ignition sensitivity of ZrH2, TiH2 and MgH2 gradually increased. When the concentration of MgH2 is 83.0 g/m3 in Hartmann device, the ignition energy attained a minimum of 10.0 mJ. The explosion pressure of MgH2 were 1.44 times and 1.76 times that of TiH2 and ZrH2, respectively, and the explosion pressure rising rate were 3.97 times and 9.96 times that of TiH2 and ZrH2, respectively, through the spherical pressure vessel. It indicated that the reaction reactivity and reaction rate of MgH2 were higher than that of TiH2 and ZrH2. In addition, to conduct in-depth theoretical analysis of ignition sensitivity and explosion severity, gas production and combus-tion heat per unit mass of ZrH2, TiH2 and MgH2 were tested by mercury manometer and oxygen bomb calorimetry. The experimental results revealed that MgH2 had a relatively high gas production per unit mass (5.15 mL/g), while TiH2 and ZrH2 both had a gas production of less than 2.0 mL/g. Their thermal stability gradually increased, leading to a gradual increase in ignition energy. Furthermore, compared with theoretical combustion heat, the combustion ratio of MgH2, TiH2 and ZrH2 was more than 96.0%, with combustion heat value of 29.96, 20.94 and 12.22 MJ/kg, respectively, which was consistent with the explosion pressure and explosion severity test results.     

光栅过滤法测试陶瓷磨削表面残余应力

采用表面形貌技术对陶瓷磨削表面残余应力进行测试研究,对表面粗糙度曲线经过数据截取、滤波以及规范化处理后可得到表面挠度曲线,认为,此方法与X射线衍射法相比测试结果较接近,是测试残余应力的有效方法;其数据处理过程是保证测试精度的关键;挠度变化是个渐变的过程。     

射击与通信实践环节的综合训练

以院实施射击、通信课改革为出发点,针对改革实施的必要性、指导思想、改革的内容、改革的措施等几个问题进行了具体论述。为下一步改革提供几点借鉴,促进改革的顺利实施。