基于改进Morison公式的海上漂浮软管波浪载荷计算

针对海上漂浮软管波浪载荷计算,分析了软管在海上的形态和受力特点,建立了海上漂浮软管力学分析模型,指出直接运用现有Morison方程计算漂浮软管波浪载荷存在的不足,并根据基本原理提出了改进Morison方程。对海上软质管线处于一定海况,分别运用改进Morison方程与现有Morison方程计算海上波浪载荷,并运用ANSYS软件建立软管模型,结果表明现有Morison方程不适用于计算海上漂浮软管波浪载荷,载荷计算结果偏高约15%,从而验证了改进Morison方程的精确性,有利于准确分析波浪载荷对海上漂浮软管的作用情况。     

Two novel critical shock models based on Markov renewal processes

In this paper, we investigate systems subject to random shocks that are classified into critical and noncritical categories, and develop two novel critical shock models. Classical extreme shock models and run shock models are special cases of our developed models. The system fails when the total number of critical shocks reaches a predetermined threshold, or when the system stays in an environment that induces critical shocks for a preset threshold time, corresponding to failure mechanisms of the developed two critical shock models respectively. Markov renewal processes are employed to capture the magnitude and interarrival time dependency of environment-induced shocks. Explicit formulas for systems under the two critical shock models are derived, including the reliability function, the mean time to failure and so on. Furthermore, the two critical shock models are extended to the random threshold case and the integrated case where formulas of the reliability indexes of the systems are provided. Finally, a case study of a lithium-ion battery system is conducted to illustrate the proposed models and the obtained results.     

Controllable combustion behaviors of the laser-controlled solid propellant

Microsatellites have been widely applied in the fields of communication,remote sensing,navigation and science exploration due to its characteristics of low cost,flexible launch mode and short development period.However,conventional solid-propellant have difficulties in starting and interrupting combustion because combustion is autonomously sustained after ignition.Herein,we proposed a new type of solid-propellant named laser-controlled solid propellant,which is sensitive to laser irradiation and can be started or interrupted by switching on/off the continuous wave laser.To demonstrate the feasibility and investigate the controllable combustion behaviors under different laser on/off conditions,the combus-tion parameters including burning rate,ignition delay time and platform pressure were tested using pressure sensor,high-speed camera and thermographic camera.The results showed that the increase of laser-on or laser-off duration both will lead to the decrease of propellant combustion performance during re-ignition and re-combustion process.This is mainly attributed to the laser attenuation caused by the accumulation of combustion residue and the change of chamber ambient temperature.Simultaneously,the multiple ignition tests revealed that the increased chamber ambient temperature after combustion can make up for the energy loss of laser attenuation and expansion of chamber cavity.However,the laser-controlled combustion performance of solid propellant displayed a decrease trend with the addi-tion of ignition times.Nevertheless,the results still exhibited good laser-controlled agility of laser-controlled solid propellant and manifested its inspiring potential in many aspects of space missions.     

The effect of al particle size on thermal decomposition,mechanical strength and sensitivity of Al/ZrH2/PTFE composite

To study the thermal decomposition of Al/ZrH2/PTFE with different Al particle size as well as mechanical strength and impact sensitivity under medium and low strain rates, molding-vacuum sintering was adopted to prepare four groups of power materials and cylindrical specimens with different Al particle size. The active decomposition temperature of ZrH2 was obtained by TG-DSC, and the quasi-static me-chanics/reaction characteristics as well as the impact sensitivity of the specimen were studied respec-tively by quasi-static compression and drop-hammer test. The results show that the yield strength of the material decreased with the increase of the Al particle size, while the compressive strength, failure strain and toughness increased first and then decreased, which reached the maximum values of 116.61 MPa, 191％, and 119.9 MJ/m respectively when the Al particle size is 12—14μm because of particle size grading. The specimens with the highest strength and toughness formed circumferential open cracks and reacted partly when pressed. Those with developmental cracks formed inside did not react. It is considered that fracture of specimens first triggered initial reaction between Al and PTFE to release an amount of heat. Then ZrH2 was activated and decomposed, and participated in subsequent reaction to generate ZrC. The impact sensitivity of the specimens decreased with the increase of Al particle size.     

Influence of propagation direction on operation performance of rotating detonation combustor with turbine guide vane

Due to the pressure gain combustion characteristics, the rotating detonation combustor (RDC) can enhance thermodynamic cycle efficiency. Therefore, the performance of gas-turbine engine can be further improved with this combustion technology. In the present study, the RDC operation performance with a turbine guide vane (TGV) is experimentally investigated. Hydrogen and air are used as propellants while hydrogen and air mass flow rate are about 16.1 g/s and 500 g/s and the equivalence ratio is about 1.0. A pre-detonator is used to ignite the mixture. High-frequency dynamic pressure transducers and silicon pressure sensors are employed to measure pressure oscillations and static pressure in the combustion chamber. The experimental results show that the steady propagation of rotating detonation wave (RDW) is observed in the combustion chamber and the mean propagation velocity is above 1650 m/s, reaching over 84% of theoretical Chapman-Jouguet detonation velocity. Clockwise and counterclockwise propagation directions of RDW are obtained. For clockwise propagation direction, the static pressure is about 15% higher in the combustor compared with counterclockwise propagation direction, but the RDW dominant frequency is lower. When the oblique shock wave propagates across the TGV, the pressure oscillations reduces significantly. In addition, as the detonation products flow through the TGV, the static pressure drops up to 32% and 43% for clockwise and counterclockwise propagation process respectively.     

Theoretical design of new bridge-ring insensitive high energy compounds by selected normal Diels-Alder reactions between NH2-substituted oxazoles and NO2/NF2/NHNO2-substituted ethylenes/acetylenes

In this work, NH₂-substituted oxazoles and NO₂/NF₂/NHNO₂-substituted ethylenes/acetylenes were designed and used as dienes and dienophiles, respectively, in order to develop new bridge-ring insensitive high energy compounds through the Diels-Alder reaction between them. The reaction type, reaction feasibility and performance of reaction products were investigated in detail theoretically. The results showed that dienes most possibly react with dienophiles through the HOMO-diene controlled normal Diels-Alder reaction at relatively low energy barrier. Tetranitroethylene could react with the designed dienes much more easily than other dienophiles, and was employed to further design 29 new bridge-ring energetic compounds. Due to high heat of formation, density and oxygen balance, all designed bridge-ring energetic compounds have outstanding detonation performance, 16 of them have higher energy than HMX (1,3,5,7-tetranitro-1,3,5,7-tetrazocine) and 2 others even possess comparative energy with the representative of high energy compounds CL-20 (2,4,6,8,10,12-hexanitro-2,4,6,8,10,12-hexaazaisowurtzitane). The predicted average h₅₀ value of these bridge-ring energetic compounds is 83 cm, showing their low impact sensitivity. The NH₂ groups could obviously impel the proceeding of Diels-Alder reactions, but would slightly decrease the energy and sensitivity performance. In all, the new designed bridge-ring compounds have both high energy and low sensitivity, and may be produced through Diels-Alder reactions at relatively low energy barrier. This paper may be helpful for the theoretical design and experiment synthesis of new advanced insensitive high energy compounds.     

A cooperative interference resource allocation method based on improved firefly algorithm

To deal with the radio frequency threat posed by modern complex radar networks to aircraft, we researched the unmanned aerial vehicle (UAV) formations radar countermeasures, aiming at the solution of radar jamming resource allocation under system countermeasures. A jamming resource allocation method based on an improved firefly algorithm (FA) is proposed. Firstly, the comprehensive factors affecting the level of threat and interference efficiency of radiation source are quantified by a fuzzy comprehensive evaluation. Besides, the interference efficiency matrix and the objective function of the allocation model are determined to establish the interference resource allocation model. Finally, A mutation operator and an adaptive heuristic are integtated into the FA algorithm, which searches an interference resource allocation scheme. The simulation results show that the improved FA algorithm can compensate for the deficiencies of the FA algorithm. The improved FA algorithm provides a more sci-entific and reasonable decision-making plan for aircraft mission allocation and can effectively deal with the battlefield threats of the enemy radar network. Moreover, in terms of convergence accuracy and speed as well as algorithm stability, the improved FA algorithm is superior to the simulated annealing algorithm (SA), the niche genetic algorithm (NGA), the improved discrete cuckoo algorithm (IDCS), the mutant firefly algorithm (MFA), the cuckoo search and fireflies algorithm (CSFA), and the best neighbor firefly algorithm (BNFA).     

窄带环境下的远程分布式服务调用优化与验证方法

指挥控制系统是现代化作战的核心环节和重要支撑,通过对网络化的作战需求分析,针对窄带环境下实现分布式服务远程访问存在错误率高和延时长等问题,应用精简协议、压缩数据包和大小包数据的动态拆分、聚合等方法,提高分布式指挥控制系统在窄带环境下的适应性.通过搭建不同的窄带模拟环境,验证了提出的优化方法能够有效提高服务在窄带环境下的注册、被发现和被调用的能力.