基于循环平稳的卫星信道多普勒频移估计

基于线性调制信号的循环平稳特性,卫星信道多普勒频移的估计可以通过求解发送信号与接收信号的循环相关函数关系得到.借助循环谱函数推导出发送信号的循环相关函数,接收信号的循环相关函数则对信号本身及其有限差分进行计算.仿真结果说明了该算法对信道中的干扰与噪声不敏感,在多普勒频移较大时,该算法具有良好的估计精度;同时该算法还具有低复杂度和应用灵活的特点.     

基于移动目标的DOA估计偏差校正

针对移动目标的波达方向估计容易出现偏差的问题,提出一种利用频移信息修正方位估计偏差的算法,解决了传统方位估计算法不能适用于高速移动目标或平台的问题。该方法利用基阵平台与目标的径向移动速度,估计中心频率偏移,然后利用频移信息修正传统的方位估计结果。仿真结果表明,该算法可以极大地提高移动目标的方位估计精度。此外,该算法对阵列的阵型和方位估计算法没有任何限制,因此具有广泛的适用性和较强的工程实用价值。     

引入块内码元频数抽样的块内频数检测识别方案

为识别链路层比特流是否加密,以未加密与加密数据在随机统计特性上的差异为依据,利用随机性检测的方法对加密比特流进行识别.在不同比特流长度条件下对3种典型随机性检测方法的识别率进行了比较研究.针对3种检测方法均对长度较短的未加密比特流识别率较低的问题,在块内频数检测的基础上,提出了基于块内码元频数抽样的比特流预处理方案,以及块内频数检测最优分块长度选择方案,并对预处理方案对识别率的影响进行了分析.实验结果表明,提出的方案可以显著提高块内频数检测对未加密比特流的识别率.     

声表面波对汽油胶质含量响应特性的理论与实验研究

从理论上分析了沉积于压电基片表面的汽油胶质对声表面波（SAW）传播特性的影响,在此基础上参照国家标准规定的汽油胶质含量测定试验条件,基于自制的SAW传感器,实验研究了SAW对不同汽油胶质含量的响应特性.结果表明SAW传感器的中心频率及幅度随SAW传播路径上沉积胶质的含量变化表现出敏感且单调的变化规律,这一结果可为车用汽油胶质含量的快速检测提供参考.     

Damage visualization and deformation measurement in glass laminates during projectile penetration

Transparent armor consists of glass-polymer laminates in most cases. The formation and propagation of damage in the different glass layers has a strong influence on the ballistic resistance of such laminates. In order to clarify the course of events during projectile penetration, an experimental technique was developed, which allows visualizing the onset and propagation of damage in each single layer of the laminate. A telecentric objective lens was used together with a microsecond video camera that allows recording 100 frames at a maximum rate of 1 MHz in a backlit photography set-up. With this technique, the damage evolution could be visualized in glass laminates consisting of four glass layers with lateral dimensions 500 mm × 500 mm. Damage evolution was recorded during penetration of 7.62 mm AP projectiles with tungsten carbide core and a total mass of 11.1 g in the impact velocity range from 800 to 880 m/s. In order to measure the deformation of single glass plates within the laminates, a piece of reflecting tape was attached to the corresponding glass plate, and photonic Doppler velocimetry (PDV) was applied. With the photonic Doppler velocimeter, an infrared laser is used to illuminate an object to be measured and the Doppler-shifted light is superimposed to a reference light beam at the detector. The simultaneous visualization and PDV measurement of the glass deformation allow determining the deformation at the time of the onset of fracture. The analysis of the experimental data was supported by numerical simulations, using the AUTODYN commercial hydro-code.     

玻璃瓶动态图像检测运动模拟平台

动态图像检测中,如何在指定位置快速而准确地捕捉到运动物体的图像是最基本的环节。试验验证图像检测装置的成像特性,成为动态图像检测研究的重要内容之一。以变频器控制电动机为核心,通过变频器内部参数编程和外部简单的辅助控制电路,构建了运动平稳、速度可调、具有自动保护功能的模拟平台。该平台适于动态图像检测中普通运动物体的快速模拟,已成功地用于玻璃瓶动态图像装置中,达到了预期目的。     

低频UWBSAR辐射校准模型

低频超宽带合成孔径雷达(Ultra Wide Band Synthetic Aperture Radar,UWBSAR)的辐射校准是系统研制和应用过程中必须面对的课题。低频UWBSAR的特点使得常规SAR辐射校准技术不再适用。充分考虑校准参数随频率和方位角的变化,给出适合该系统的辐射校准方法,得到低频UWBSAR图像辐射校准模型。利用该模型,对系统辐射校准误差进行了分析。     

非局部弹性杆固有频率的Ritz法求解

采用Ritz法求解了非局部弹性直杆的固有频率问题。非局部弹性理论与经典弹性理论相对应,区别在于非局部理论中,一点的应力与该点以及其周围区域的应变都有关,并采用核函数来表征这种相关性。基于Eringen提出的非局部弹性模型,针对三种给定核函数,用Ritz法进行了直杆的动力学分析。并针对两种边界条件给出直杆的固有频率,与其它方法比较,该方法具有可以针对多种核函数求解,精度可控,易于编程等优点。     

Sensor radiation interception risk control in target tracking

This paper is mainly on the problem of radiation interception risk control in sensor network for target tracking. Firstly, the sensor radiation interception risk is defined as the product of the interception probability and the cost caused by the interception. Secondly, the radiation interception probability model and cost model are established, based on which the calculation method of interception risk can be obtained. Thirdly, a sensor scheduling model of radiation risk control is established, taking the minimum interception risk as the objective function. Then the Hungarian algorithm is proposed to obtain sensor scheduling scheme. Finally, simulation experiments are mad to prove the effectiveness of the methods proposed in this paper, which shows that compared with the sensor radiation interception probability control method, the interception risk control method can keep the sensor scheduling scheme in low risk as well as protect sensors of importance in the sensor network.     

Experimental study on the detonation process of a pulse detonation engine with ionized seeds

An experimental platform of a pulse detonation engine (PDE) was established to study the effect of different K₂CO₃ ionized seed mass contents on the detonation process. The pressure and ion concentration were detected in the detonation process of the PDE with different contents of ionized seeds. The initiation process of the PDE at different ignition frequencies was studied. The results show that the gas conductivity in the detonation process increased by adding ionized seeds to the PDE tube, and the conductivity increased with the increase in ionized seed mass content. With the increase in ionized seed mass content, the range of the conductivity decreased. The PDE was successfully ignited and formed a stable detonation wave at ignition frequencies of 5 Hz and 10 Hz, and the peak pressure of the stable detonation with the ignition frequency of 5 Hz was 17% higher than that with an ignition frequency of 10 Hz. The detonation wave intensity was weakened and degenerated to a shock wave that propagated in the tube without the fuel filled at the ignition frequency of 20 Hz.