身管内弹道性能改变量的静态标定研究

目前国内外静态标定火炮身管内弹道性能改变量的方法,都存在着原理和精度不高的缺陷。采用多特征截面的标定方法可取得满意的精度,本文论述了其理论基础、精度及应用领域。     

内可逆卡诺热泵的生态学优化性能

本文导出了内可逆卡诺热泵的供热量、供热率和供热系数的耗散量,以反映热泵供热率π与其耗散φ_cT_Lσ,即热泵熵产率σ、低温热源温度T_L和可逆供热系数φ_c乘积之间最佳折衷的“生态学”性能E=π-φ_cT_Lσ为目标,基于牛顿和线性唯象传热定律,研究内可逆卡诺热泵的优化问题,得到最大E性能时的供热系数界限及相应的供热率和熵产率。     

移动电站整机性能自动测试仪的研制

本文研究将分布式双处理器控制技术应用于移动电站性能测试中,构成移动电站整机性能参数自动测试仪,该测试仪比传统测试方法提高效率8～10倍,且操作简便。     

微波雷达目标信号模拟器及其应用

本文为在野战条件下检测雷达测距系统的性能提供一种新型微波目标信号模拟器,闸述其工作原理及功能。除在检测雷达测距系统性能上已得到实际应用外,还论述了可以进一步开发的应用项目,因为不受场地和气候条件的限制,从而获得较好的效能、效率和效益。     

Q∝T~n时不可逆卡诺热泵的最优性能

非线性传热条件下的内可逆卡诺热机最优性能有了一些讨论,本文将导出不可逆卡诺热泵工作于非线性传热 Q■条件下,最佳供热系数д与泵热率π的关系。据此可确定任意泵热率时所对应的供热系数界限。最后,讨论了这一关系的一些应用,所得结果包含了经典热力学及内可逆线性传热情况下的有关结论,为实际热泵设计提供新的理论依据。     

融合跟踪系统性能的综合评估

首先通过分析融合跟踪系统的性能评估需求,并结合已有性能评估指标,制定出一组相对完备的评估指标.使用时间加权平均的方法,详细描述了各指标的定义及其计算方法;其次,基于该组指标提出了系统性能的模糊综合评价方法,说明了该评价方法的原理及其在融合跟踪系统性能评估中的具体实现.对融合跟踪系统的测试实验表明,指标体系设置合理,评估方法可操作性强.     

小子样条件下基于Normal-Poisson过程的性能可靠性评定

对于高可靠、长寿命产品,基于性能退化数据分析可靠性是一种行之有效的技术途径。结合航空航天产品性能退化的机理与现场试验小子样的特点,建立了基于Normal-Poisson过程的性能退化模型。论文在对产品性能退化建模的基础上,结合Bayes方法给出了退化模型参数的估计算法和可靠性推断的公式,最后结合实例说明了方法的有效性。     

Study on performance degradation and failure analysis of machine gun barrel

An increase in the use of the gun barrel will cause wear of the inner wall, which reduces the muzzle velocity and the spin rate of the projectile. The off-bore flight attitude and trajectory of the projectile also change, affecting the shooting power and the accuracy. Exterior ballistic data of a high-speed spinning projectile are required to study the performance change. Therefore, based on the barrel's accelerated life test, the whole process of projectile shooting is reproduced using numerical simulation technology, and key information on the ballistic performance change at each shooting stage are acquired. Studies have shown that in the later stages of barrel shooting, the accuracy of shooting has not decreased significantly. However, it is found that the angle of attack of the projectile increases as the wear of the barrel increases. The maximum angle of attack reaches 0.106 rad when the number of shots reaches 4300. Meanwhile, elliptical bullet hole has appeared on the target at this shooting stage. Through combining external ballistic theory with simulation results, the primary reason of this phenomenon is found to be a significant decrease in the muzzle spin rate of the projectile. At the end of the barrel life, the projectile muzzle spin rate is 57.5% lower than that of a barrel without wear.     

遥感图像融合效果客观评价

能够对不同的融合技术的性能进行客观、系统、全面地评价,成为目前空间信息处理以及遥感图像融合研究领域中亟待解决的问题。对国内外遥感图像融合系统及技术的发展历程进行了介绍,重点分析了遥感图像融合效果评估技术的研究现状,归纳了现有的效果评估方法。通过实验,进一步讨论了当前遥感图像融合效果评估技术所存在的主要问题,有助于明确该领域的发展方向和研究侧重点,为遥感图像融合系统及空间信息处理的研究奠定基础。     

Fully sequential procedures for comparing constrained systems via simulation

We consider the problem of finding the system with the best primary performance measure among a finite number of simulated systems in the presence of a stochastic constraint on a single real‐valued secondary performance measure. Solving this problem requires the identification and removal from consideration of infeasible systems (Phase I) and of systems whose primary performance measure is dominated by that of other feasible systems (Phase II). We use indifference zones in both phases and consider two approaches, namely, carrying out Phases I and II sequentially and carrying out Phases I and II simultaneously, and we provide specific example procedures of each type. We present theoretical results guaranteeing that our approaches (general and specific, sequential and simultaneous) yield the best system with at least a prespecified probability, and we provide a portion of an extensive numerical study aimed at evaluating and comparing the performance of our approaches. The experimental results show that both new procedures are useful for constrained ranking and selection, with neither procedure showing uniform superiority over the other.© 2010 Wiley Periodicals, Inc. Naval Research Logistics, 2010