基于CAN总线的储油罐液位测量系统

为解决储油罐液位测量存在的测量精度不高、价格偏高、可靠性低等问题,引入CAN总线,给出了基于CAN总线的储油罐液位测量系统的总体方案。该系统主要由监控站和现场测控单元组成,对现场测控单元的硬件设计、系统软件设计作了重点介绍。系统已初步形成样机,市场应用前景看好。     

爆电换能的理论分析

考虑了铁电介质的介电松弛和电导率松弛,计及冲击波阵面在样品中传播过程的影响,改进了垂直模式冲击波加载铁电陶瓷电响应的理论,且理论分析与实验结果基本一致。     

Investigation on energy output structure of explosives near-ground explosion

In order to give the energy output structure of typical explosives near-ground explosion in real ground conditions, the free-field shockwave, ground reflection shockwave and Mach wave overpressure time history of composition B explosive, RDX explosive and aluminized explosive were measured by air pressure sensors and ground pressure sensors. The shape of the free-field shock wave, ground reflection shock wave, and Mach wave and explosion flame were captured by high-speed camera. The experimental results show that, at the same horizontal distance from the initiation point, the peak overpressure of explosive shock wave of composition B explosive, both in the air and on the ground, is less than that of RDX and aluminized explosives. At a distance of 3.0 m from the initiation point, the peak overpressure of aluminized explosives is slightly less than that of RDX explosives. Owing to the exothermic effect of aluminum powder, the pressure drop of aluminized explosives is slower than that of RDX explosives. At 5.0 m from the initiation point, the peak overpressure of aluminized explosives is larger than that of RDX explosives. At the same position from the initiation point, among the three kinds of explosives, the impulse of aluminized explosives is the maximum and the impulse of composition B explosives is the minimum. With the increase of the horizontal distance from the initiation point, the height of Mach triple-points (Mach steam) of the three explosives increases gradually. At the same horizontal distance from the initiation point, there is poorly difference in the height of Mach triple-points between aluminized explosive and RDX explosive, and the height of Mach triple-points of composition B explosive is much smaller than that of other two explosives. The maximum diameter and duration of the fireball formed by aluminized explosives are the largest, followed by composition B explosive, and the maximum diameter and duration of the fireball formed by RDX explosive are the smallest.     

Experimental study on explosion dispersion process of a multi-layer composite charge under different initiation modes

The influence of initiation modes on the explosive dispersion process of the multi-layer composite charge (MCC) was studied. Overpressure sensors and high-speed photography system were used to investigate the energy release process of an MCC with a specific structure. The shock wave pressure and explosive dispersion characteristics of the MCC under different initiation modes were compared. The forming and expanding process of the shock wave of the composite charge under different initiation modes was determined. The separation position of the shock wave and fireball interface was determined. The calculation formulas of the shock radius and overpressure of the composite charge are presented. The radius of the shock wave of the composite charge was significantly affected by the initiation mode. Moreover, the development process of the composite explosive fireball under different initiation modes was analyzed, the variation rules of the composite charge dispersion radius and fireball dispersion velocity with time were obtained under the different initiation modes, the explosion energy release rate of composite charge under simultaneous initiation modes was the highest, and the peak overpressure under the simultaneous initiation mode was 1.61 times that of central single-point initiation.     

三维视觉运动建模中碰撞检测算法研究

三维视觉建模是建立虚似现实 (VR)系统的基础 ,运动建模是三维视觉建模的重要组成部分。研究了运动建模中碰撞检测算法     

DSP实现低信噪比条件下点目标检测与跟踪

针对嵌入式实时图像处理系统中 ,复杂背景低信噪比条件下红外运动点目标检测及跟踪所采用的处理算法 ,包括基于空域低通滤波的多图像平均法和自适应阈值分割法以及基于目标运动时空连续性目标运动轨迹拟合及目标运动轨迹参数预测算法 ,进行基于二维数组组合方式存储结构的算法复杂度估计 ,并将上述算法在TI公司的TMS32 0C6 2 0 1EVM板上进行实时性能评测 ,说明上述算法在基于具有软件流水性能的TMS32 0C6x系列DSP嵌入式实时图像处理系统中实现的可行性。     

AM波在LC电路中的不失真条件

分析AM波通过LC谐振放大器时的不失真条件,提出解决失真的办法.     

岸基光电综合警戒系统发展分析

介绍了红外警戒系统、激光警戒系统和紫外警戒系统的基本原理、探测方法及发展现状 ;比较了这 3种典型探测方法的优缺点 ;分析了岸基光电综合警戒系统的结构原理 ,探讨了它的发展趋势 .     

船用电缆绝缘电阻自动检测精度的分析与研究

提出了一种实际的船用电缆绝缘电阻检测方案 ,包括信号变换电路和方案的硬件与软件结构 .分析了检测误差产生的主要原因 ,并提出了两种提高检测精度的措施     

数据驱动的复杂系统非预期故障诊断通用过程模型

提高对复杂系统非预期故障诊断能力是故障诊断领域的难点。结合非预期故障诊断内涵及基本原理,构建了一种用于复杂系统非预期故障诊断的通用过程模型。该模型采用四层递进结构,包括四个主要模型,即预期(已知)故障检测模型、预期(已知)故障识别模型、非预期(未知)故障检测模型和非预期(未知)故障识别模型。分析了各模型所包含的关键问题及其相应的实现算法,包括检测统计量的构建及评估、故障特征方向提取、故障识别器设计及故障贡献率计算。该通用过程模型规范了复杂系统非预期故障的诊断流程,明确了数据驱动的实现原理。以卫星姿态控制系统为例,验证了非预期故障诊断通用过程模型的有效性。