齿轮箱振动测试与分析

在对某型齿轮箱的模态、振动烈度和振动加速度进行测试的基础上,详细分析了测试结果.模态测试得到了齿轮箱的振型和模态参数,振动烈度测试结果表明该齿轮箱处于良好工作状态,振动加速度测试结果显示该齿轮箱的减振措施达到了预期的效果.最后,对测试提出了建议.     

光电指向器水平度测量算法

通过对光电跟踪仪安装时水平度调整方法的研究,提出了利用坐标变换算法,用以实现光电跟踪仪安装时水平度的快速调整.利用该算法不但可以减少安装时的测量次数,节约安装调整时间,而且提高了设备安装时的测量精度,具有广泛的推广应用价值.文中还对该方法的测量计算误差进行了分析.     

风洞现场电磁干扰测量研究

根据风洞现场测控系统的特点,对风洞现场的电磁干扰测量方法和技术进行研究,并在风洞中进行试验,得到了相关的试验数据．通过对数据的分析可以得出：影响风洞现场测控系统的电磁干扰源主要是大功率变频装置,耦合途径为空间辐射和电源线传导．     

Ricochet quantification using a multiple sensor approach

This study investigates the ricochet behaviour of three different small-arms projectile types using a novel ricochet measuring device.The results can be used to estimate the danger potential of ricochets on shooting ranges.A ricochet is the change of direction and velocity of a projectile after impacting an oblique surface.This impact produces strong vibrations on a rigid plate.During this impact,flexural waves travel radially outwards from the point of impact.These waves are used to determine the properties of the impactor with accelerometers situated on the target surface.With the use of two measurement plates,one can produce a ricochet and detect the velocity at the same time.Accelerometers are suitable for accurate momentum measurements of single impacts.However,depending upon strike velocity and the impact angle,a ricochet can separate in multiple fragments after being deflected.From the operational safety perspective,these fragments need to be detected,as well.The approach of a coupled sensor concept was chosen to solve this problem.Thermographic sensors were additionally used to visualise the heat which is produced after pene-trating a rubber layer pasted in front of the steel target plate.With this approach one was able to detect the position of impact.The investigations showed that the measurement system performance is better with a multiple sensor design,which includes accelerometers for the velocity,impact strength and partly the position measurement,while the thermographic sensor was used for the position measurement and partly the momentum measurement.The investigated ammunition showed plausible fragmentation behaviour,and the results can already be used to estimate the danger potential of different ammunition types.Frangible projectiles fragment to small particles already after being deflected under a small angle.However,Full Metal Jacket projectiles with or without a steel core do not fragment under angles which are less than 5°.The objective of the paper is to demonstrate the possibility of measuring the complex ricochet me-chanics of small projectiles using standard accelerometers with the adequate signal processing approach.This measuring system is supported by an off the shelf thermographic camera.     

A novel launch dynamics measurement system for multiple launch rocket system and comparative analysis with numerical simulations

In this paper,a novel launch dynamics measurement system based on the photoelectric sensor pair is built.The actual muzzle time(i.e.a time duration that originates from the initial movement to the rocket's departure from the muzzle)and the muzzle velocity are measured.Compared with the classical methods,the actual muzzle time is obtained by eliminating the ignition delay.The comparative analysis method is proposed with numerical simulations established by the transfer matrix method for multibody systems.The experiment results indicate that the proposed measurement system can effectively measure the actual muzzle time and reduce the error of classical methods,which match well with the simulation results showing the launch dynamics model is reliable and helpful for further analysis and design of the MLRS.     

A critical look at the U.S. deceased‐donor organ procurement and utilization system

The U.S. system for procuring and utilizing deceased‐donor organs for transplantation has been studied and written about in many articles. The purpose of this paper is to examine the interactions between the elements that comprise this system, and point out improvement opportunities that may be affected through operations research/management techniques. The authors demonstrate the need for developing data‐driven and analytic tools. In fact, data is used to generate hypotheses and support claims throughout the paper. The paper also points out the need to fully leverage data that is available to researchers, and to seek data that is currently not deposited in a centralized archive.     

基于双光频梳及受激布里渊散射的微波频率测量

提出了一种基于双光频梳和受激布里渊散射的高精度微波频率测量方法,利用两个双平行马赫-曾德尔调制器将待测微波信号和扫描信号调制在两路光频梳上,并分别作为信号光和泵浦光输入色散位移光纤中。利用双光频梳和不断频移的扫描信号,系统可同时实现波分复用和时分复用。同时,在双光频梳和受激布里渊散射的作用下,系统可发生一系列的受激布里渊散射,通过测量各信道输出的光功率实现待测微波频率的测量。为进一步提升测量精度,利用测量得到的光功率值构建幅度比较函数,从而实现频率测量误差修正。通过实验仿真验证了所提方法的有效性,测量误差为±2.5 MHz。