一种基于加权DSmT的序列图像目标识别方法

通过对自动目标识别系统研究与分析,将DSmT引入到飞机序列图像识别中,构建基本置信指派及分类规则,提出了一种基于加权DSmT的序列图像目标识别方法,在分析权值选择特点的基础上,根据特征信息的置信指派组合有效权值,并且给出了基于加权DSmT融合规则的序列图像目标识别的流程,仿真结果表明,该方法提高了序列图像目标识别的准确性.     

基于信息需求的情报支持效能分析

经典的侦察与监测(S&R)系统效能分析方法存在模型难以建立、结果不准确等问题。考虑到S&R系统的目的是提供情报支持,提出一种基于信息需求的S&R系统情报支持效能分析方法。该方法以用户的信息需求为度量基准量,比较S&R系统性能对信息需求的满足度,并以此满足度作为S&R系统效能度量的指标。仿真实例表明了新方法的有用性。     

车联网环境下车辆协同高精度定位研究进展

车辆位置信息是许多智能交通应用的基础,如车辆导航、路径规划和车辆编队等.现有研究中融合单车车载多源传感器的定位方法无法有效解决城市峡谷、隧道和立交桥等卫星信号不可用条件下的车辆定位问题.围绕车辆高精度定位进行了综合评述,主要深入研究分析了车辆协同定位技术.首先分析了单车自主定位的关键技术及其主要应用场景;然后对车辆协同...     

非致命防暴动能弹作战效能评估

提出了非致命防暴动能弹作战效能的评估法,分析了非致命防暴动能弹的技术性能,建立了以非致命性为核心指标的防暴动能弹效能指标体系。采用定性分析与定量分析相结合,将集对分析法应用到了非致命防暴动能弹的效能评估中,对3种防暴动能弹进行了效能评估。为非致命防暴动能弹的研发生产提供了重要的理论支撑。     

2K-H 行星传动的极限传动比

在行星轮系机构综合中,研究行星轮数目与极限传动比的关系有着极其重要的意义。本文根据２Ｋ─Ｈ行星轮系机构的同心条件、安装条件和邻接条件,采用统一的符号,对满足上述条件的所有（六种）２Ｋ─Ｈ行星轮系机构,导出了行星轮个数与极限传动比的统一关系式,得到了所有２Ｋ─Ｈ行星轮系机构的极限传动比计算公式,为２Ｋ─Ｈ行星轮系机构的综合提供了理论根据。     

融合初值校准与二阶逼近的单星测频定位算法

为减小单星测频定位的误差,提出一种融合初值校准与二阶逼近的单星测频定位算法。该算法在卫星接收信号多普勒频移为零的时间点,通过测距获得卫星到定位目标的距离信息,利用距离信息修正轨道平面与定位目标的几何关系,为初值的选取提供校准手段;将校准的初值代入含二阶级数的定位方程泰勒展开式,通过较少次数的迭代得到定位目标的真实位置,从而降低定位的算法复杂度,提高定位精度。仿真结果表明,所提出的算法与多普勒单星定位算法相比,迭代次数和定位误差大幅度减小,其实现简单、计算量少、误差小,在单星定位研究领域具有较高的理论价值和实用价值。     

Study on performance degradation and failure analysis of machine gun barrel

An increase in the use of the gun barrel will cause wear of the inner wall, which reduces the muzzle velocity and the spin rate of the projectile. The off-bore flight attitude and trajectory of the projectile also change, affecting the shooting power and the accuracy. Exterior ballistic data of a high-speed spinning projectile are required to study the performance change. Therefore, based on the barrel's accelerated life test, the whole process of projectile shooting is reproduced using numerical simulation technology, and key information on the ballistic performance change at each shooting stage are acquired. Studies have shown that in the later stages of barrel shooting, the accuracy of shooting has not decreased significantly. However, it is found that the angle of attack of the projectile increases as the wear of the barrel increases. The maximum angle of attack reaches 0.106 rad when the number of shots reaches 4300. Meanwhile, elliptical bullet hole has appeared on the target at this shooting stage. Through combining external ballistic theory with simulation results, the primary reason of this phenomenon is found to be a significant decrease in the muzzle spin rate of the projectile. At the end of the barrel life, the projectile muzzle spin rate is 57.5% lower than that of a barrel without wear.     

Numerical simulation of the blast wave of a multilayer composite charge

The numerical simulation of a blast wave of a multilayer composite charge is investigated. A calculation model of the near-field explosion and far-field propagation of the shock wave of a composite charge is established using the AUTODYN finite element program. Results of the near-field and far-field calculations of the shock wave respectively converge at cell sizes of 0.25–0.5 cm and 1–3 cm. The Euler––flux-corrected transport solver is found to be suitable for the far-field calculation after mapping. A numerical simulation is conducted to study the formation, propagation, and interaction of the shock wave of the composite charge for different initiation modes. It is found that the initiation mode obviously affects the shock-wave waveform and pressure distribution of the composite charge. Additionally, it is found that the area of the overpressure distribution is greatest for internal and external simultaneous initiation, and the peak pressure of the shock wave exponentially decays, fitting the calculation formula of the peak overpressure attenuation under different initiation modes, which is obtained and verified by experiment. The difference between numerical and experimental results is less than 10%, and the peak overpressure of both internal and external initiation is 56.12% higher than that of central single-point initiation.     

Analysis of the stress wave and rarefaction wave produced by hypervelocity impact of sphere onto thin plate

Shock wave is emitted into the plate and sphere when a sphere hypervelocity impacts onto a thin plate. The fragmentation and phase change of the material caused by the propagation and unloading of shock wave could result in the formation of debris cloud eventually. Propagation models are deduced based on one-dimensional shock wave theory and the geometry of sphere, which uses elliptic equations (corresponding to ellipsoid equations in physical space) to describe the propagation of shock wave and the rarefaction wave. The “Effective thickness” is defined as the critical plate thickness that ensures the rarefaction wave overtake the shock wave at the back of the sphere. The “Effective thickness” is directly related to the form of the debris cloud. The relation of the “Effective thickness” and the “Optimum thickness” is also discussed. The impacts of Al spheres onto Al plates are simulated within SPH to verify the propagation models and associated theories. The results show that the wave fronts predicted by the propagation models are closer to the simulation result at higher impact velocity. The curvatures of the wave fronts decrease with the increase of impact velocities. The predicted “Effective thickness” is consistent with the simulation results. The analysis about the shock wave propagation and unloading in this paper can provide a new sight and inspiration for the quantitative study of hypervelocity impact and space debris protection.     

亚太新局势下美军两栖攻击舰队发展趋势研究

受美国亚太战略的影响,两栖攻击舰队逐步成为美军海外作战力量重要组成部分,其发展建设水平将对未来美军海外战略重心产生深远影响。本文以亚太新局势为背景,以美军两栖攻击舰队作为研究对象,基于美国防部对亚太地区未来军事部署和谋划的构想,对两栖攻击舰队部署情况、主要任务和发展趋势进行分析研究,可以预见,在未来十到十五年内,两栖攻击舰队将成为美国强势介入亚太的主要力量。