Shaped charge penetration into high- and ultrahigh-strength Steel–Fiber reactive powder concrete targets

Experiments on shaped charge penetration into high and ultrahigh strength steel-fiber reactive powder concrete (RPC) targets were performed in this paper. Results show that the variation of penetration depth and crater diameter with concrete strength is different from that of shaped charge penetration into normal strength concrete (NSC). The crater diameter of RPC is smaller than that of NSC penetrated by the shaped charge. The jet particles are strongly disturbed and hardly reach the crater bottom because they pass through the narrow channel formed by jet penetration into the RPC. The effects of radial drift velocity and gap effects of jet particles for a shaped charge penetration into RPC target are discussed. Moreover, a theoretical model is presented to describe the penetration of shaped charge into RPC target. As the concrete strength increases, the penetration resistance increases and the entrance crater diameter decreases. Given the drift velocity and narrow crater channel, the low-velocity jet particles can hardly reach the crater bottom to increase the penetration depth. Moreover, the narrow channel has a stronger interference to the jet particles with increasing concrete strength; hence, the gap effects must be considered. The drift velocity and gap effects, which are the same as penetration resistance, also have significant effects during the process of shaped charge penetration into ultrahigh-strength concrete. The crater profiles are calculated through a theoretical model, and the results are in good agreement with the experiments.     

空地作战地空导弹射击的一种仿真模型研究

空地作战仿真研究中,对地空导弹射击的仿真是非常重要的一环。给出了一种地空导弹对空中目标射击的建模方法,该方法对建立战役、战术级突防或防空仿真试验系统具有较强的实用性和适用性。     

基于冗余管理的水下航行器深度容错控制方法

随着海洋开发的日益增加,水下航行器的研究也进入了快速发展阶段,如何保证航行器在水下恶劣环境中可靠工作成为急待解决的问题,尤其对于超远航程和超长航时的航行器,其航行过程中难免会发生意外错误,因此在保证性能的同时,如何提高水下航行器的容错能力成为近年来研究的一个热点问题.提出了一种基于冗余管理(Redundancy Management)理论的水下航行器容错控制方案,方案有效利用了航行器中各传感器的冗余性,减少了硬件设备的增加,降低了成本,并利用有限元状态机方法进行了Matlab程序仿真,结果表明,整个方案设计合理,容错控制律真正达到了"容错控制"的目的.     

收发深度变化对浅海混响的影响研究

海洋中,由于种种原因可能造成声呐发射深度或接收深度发生变化,针对这一问题,研究了水听器的晃动给混响强度带来的影响。在波束位移射线简正波理论的基础上推导了浅海混响模型,仿真比较了负跃层浅海情况发射深度或接收深度上下变化1m时（小幅度变化）的混响衰减曲线,结果表明发射深度或接收深度上下变化1m时对混响衰减曲线的影响不大。可以认为水听器小幅度晃动时浅海混响相对于声源深度及接收深度是稳定的。     

A study on the surface overpressure distribution and formation of a double curvature liner under a two-point initiation

The formation mechanism of an EFP(explosively formed projectile) using a double curvature liner under the overpressure effect generated by a regular oblique reflection was investigated in this paper.Based on the detonation wave propagation theory,the change of the incident angle of the detonation wave collision at different positions and the distribution area of the overpressure on the surface of the liner were calculated.Three-dimensional numerical simulations of the formation process of the EFP with tail as well as the ability to penetrate 45# steel were performed using LS-DYNA software,and the EFP ve-locity,the penetration ability,and the forming were assessed via experiments and x-ray photographs.The experimental results coincides with those of the simulations.Results indicate that the collision of the detonation wave was controlled to be a regular oblique reflection acting on the liner by setting the di-mensions of the unit charge and maintaining the pressure at the collision point region at more than 2.4 times the CJ detonation when the incident angle approached the critical angle.The distance from the liner midline to the boundary of the area within which the pressure ratio of the regular oblique reflection pressure to the CJ detonation pressure was greater than 2.5,2,and 1.5was approximately 0.66 mm,1.32 mm,and 3.3 mm,respectively.It is noted that pressure gradient caused the liner to turn inside out in the middle to form the head of the EFP and close the two tails of the EFP at approximately 120μs.The penetration depth of the EFP into a 45# steel target exceeded 30 mm,and there was radial expansion between the head and tail of the EFE increasing the penetration resistance of the EFP.Therefore,the structural size of the unit charge and the liner can be further optimized to reduce resistance to increase the penetration ability of the EFP.     

基于随机拟合的悬浮式深弹弹阵特征建模

通过分析悬浮式深弹发射后在空中的弹道特性,建立了深弹弹着点坐标的计算模型。采取蒙特卡洛方法,分别对舰艇六自由度状态下,单管和六联装火箭深弹的弹着点坐标进行了仿真计算,对弹着点的分布规律进行了研究,并得出弹着点的联合密度函数。结果表明,在发射参数存在正态扰动下,弹着点散布区域均呈椭圆形分布,弹着点坐标均仍服从正态分布。     

A numerical study on the disturbance of explosive reactive armors to jet penetration

The disturbance of flat and V-shaped sandwich reactive armor configurations to shaped-charge jet is studied by a numerical approach. The disturbing and cutting effects of the two reactive armor configurations to the jet are successfully captured. The predicted disturbance characteristics and patterns are in fairly good agreement with the X-ray photographic observations. The residual depth of penetration into a semi-infinitive homogeneous steel target behind the reactive armor is computed for a series of jet/armor parameters. For the flat configuration, it is demonstrated that the residual penetration depth is not significantly reduced for a normal impact while it is reduced up to 75% for an oblique impact. In comparison, the V-shaped configuration reduces the penetration depth of the jet to 90%, and it is observed that the penetration depth is not sensitive to the V-shaped angle.     

针对国家导弹防御系统突防措施研究

美国为了追求绝对的安全,不顾国际社会的反对,贸然发展其国家弹道导弹防御系统。为了追求世界的制衡,必须研究如何突破弹道导弹防御系统。简述了NMD的发展演变,在分析了美国的国家导弹防御系统构成的基础上,针对其使用的拦截手段,重点分析了弹道导弹突破NMD的7种可能措施。     

舰舰协同防空的舰空导弹杀伤区分析

针对舰艇编队协同防空时的耦合杀伤区形状及纵深等问题进行了研究,以定量地对编队耦合杀伤区进行简化描述。分析了单舰对典型目标的杀伤区特性,探讨了舰艇编队的典型防空队形,研究了纵向上递阶多层次、横向上同阶耦合的"递阶封闭圈原理"。以一阶耦合杀伤区为重点,依据攻击目标的不同,将其分成相对航路捷径为零和相对航路捷径均非零两类情况建立了耦合杀伤区纵深的计算模型,并扩展到了高阶耦合的情况。研究了耦合杀伤区与舰舰间距和来袭目标进攻舷角等参数的相互关系以及灵敏度。结果表明建立的模型符合实际,具有一定的指导意义。