饱和蒸气比热为负的讨论

本文由热力学理论定量指出,只要两相平衡的饱和蒸气比热为负,饱和蒸气经绝热膨胀后成过饱和蒸气,并讨论了饱和蒸气比热为负的条件。     

相变材料下滑过程的接触熔化分析

本文对相变材料在斜面下滑过程中的接触熔化进行了分析。通过理论分析,求得料面保持恒温或变温对相变材料加热并使之匀速下滑时,相变材料的熔化速度、时间及固体瞬时高度。所得结果包含了前人的工作。     

BDS导航信号抗电离层闪烁载波跟踪的自适应卡尔曼滤波算法

电离层闪烁会引起导航信号幅度和相位的快速衰落,严重影响跟踪环路的精度和稳健性,而相比频率跟踪和伪码跟踪,载波跟踪环路更易受电离层闪烁的影响而失锁。因此,提出一种基于相位锁定指示自适应扩展卡尔曼滤波的北斗导航信号抗电离层闪烁载波跟踪算法,其以同相与正交支路的积分结果估计相位锁定指示值,并采用该指示作为控制参数对不同闪烁场景下扩展卡尔曼滤波的观测向量进行自适应调整,这不仅能够提高跟踪环路的精度和稳健性,而且能够降低扩展卡尔曼滤波发散的概率。实验结果验证了相关分析和所提跟踪算法的有效性。     

Effect of bending temperatures on the microstructure and springback of a TRIP steel sheet

Transformation-induced plasticity (TRIP) steel possesses high strength and formability, enabling the use of a thinner gauge material and allowing for the fabrication of complex shapes. In this research, we measured the effect of bending temperatures on the microstructure and air-bending springback angle of TRIP steel at temperatures from 25 to 600 °C. Real-time in situ X-ray diffraction and scanning electron microscopy were used for pre- and postbending analysis. As the prebending temperature increased from 25 °C to 600 °C, the retained austenite (RA) volume fraction decreased, and the RA transformed to bainite at temperatures above 400 °C. The springback angle was positively correlated with the prebending RA volume fraction, with the smallest springback angle achieved at 400 °C. Additionally, the springback angle was positively correlated with the bending angle, because the RA transformation ratio contributed to increased strain hardening. Further microstructure analysis revealed that the RA became elongated in the tension direction as the bending temperatures increased.     

卫星双向与单向载波联合的北斗星载钟短稳评估方法

卫星导航系统评估星载钟稳定度通常需要大型地面监测网的观测数据和复杂的钟差确定算法,不能基于单站观测数据实现。论文在分析利用单站观测数据评估星载钟短稳方法的基础上,提出了一种相对容易实现的联合卫星双向载波测距值与GNSS单向载波观测值的星载钟短稳评估方法。该方法通过卫星双向载波测距确定星地几何距离,基于消除星地几何距离的GNSS接收机载波相位观测值估算卫星相对钟差,进而实现其短稳评估。利用北斗系统观测数据进行了有效性验证,并与复杂钟差确定算法以及利用平滑广播星历的方法(SBE法)进行了对比,本文方法与复杂钟差确定算法计算的结果相符,在1000s平滑间隔内与SBE法结果一致,相对误差小于10%,1000s以上好于SBE法。     

高超声速飞行器巡航段多约束制导方法

针对高超声速飞行器巡航段飞行,建立了等高等速飞行的平衡条件,并对飞行器能否满足平衡条件开展分析。基于平衡条件提出了一种能够满足飞行过程中多约束条件以及终端航向角约束的制导方法,推导得到了满足多约束条件的最优制导律。该方法所有制导指令均采用解析公式实时获得,具有较强适应性。在各种偏差条件下对方法进行了仿真,仿真结果验证了方法的有效性。     

Adaptive phasefield modelling of crack propagation in orthotropic functionally graded materials

In this work, we extend the recently proposed adaptive phase field method to model fracture in orthotropic functionally graded materials (FGMs). A recovery type error indicator combined with quadtree decomposition is employed for adaptive mesh refinement. The proposed approach is capable of capturing the fracture process with a localized mesh refinement that provides notable gains in computational efficiency. The implementation is validated against experimental data and other nu-merical experiments on orthotropic materials with different material orientations. The results reveal an increase in the stiffness and the maximum force with increasing material orientation angle. The study is then extended to the analysis of orthotropic FGMs. It is observed that, if the gradation in fracture properties is neglected, the material gradient plays a secondary role, with the fracture behaviour being dominated by the orthotropy of the material. However, when the toughness increases along the crack propagation path, a substantial gain in fracture resistance is observed.     

集成广义模糊函数在雷达多目标分辨中的应用

多目标分辨是常规雷达功能的扩充。由于集成广义模糊函数是单、多分量多项式相位信号检测与参数估计的有效工具，将其应用于雷达多目标分辨中是完全可行的，这已被文中对雷达实测数据的分析所证实。为适应雷达实际工作需求，文中探讨了尚待进一步解决的关键问题。     

惯导辅助的三元天线阵欺骗干扰检测算法

对欺骗信号的到达角检测是目前最有效的欺骗检测方法之一,常用的到达角检测又分为载波相位单差和载波相位双差检测。载波相位单差检测技术不能应用于运动载体,载波相位双差技术对多阵元发射的欺骗信号或单路欺骗信号失效。针对该问题,提出一种惯导辅助的三元天线阵欺骗干扰检测技术,该算法主要应用于车辆运动载体,运动载体只需在某一时间段内运动一段距离即可利用该算法进行欺骗干扰检测。该算法对多阵元发射的欺骗信号或单路欺骗信号都同样有效。通过理论分析和仿真实验验证了所提方法的有效性,并得出天线阵基线长度越长,运动位移越大、欺骗源距离接收天线越近,信号入射方向与天线位移方向夹角越接近90°,该方法检测性能越优的结论。     

气动光学效应中调制传递函数的计算方法

从Maxwell方程出发 ,推导了光在湍流中传播的调制传递函数的计算公式。依据折射率起伏相关函数的两种形式 ,计算了光学相位差。根据湍流的动能和动能耗散率输运方程 ,建立了折射率起伏方差的计算模型。最后 ,指出了文中所给公式的适用范围 ,对更好地进行调制传递函数的计算提出了建议。