多点喷射空气酒精燃气发生器试验验证

为有效解决现有燃气引射气源存在的诸多缺点,适应一种引射系统大流量、小型化的需要,在综合分析各燃气引射气源方案的基础上,研制了一种以空气、酒精作为推进剂的多点喷射结构的燃气发生器,并开展了多种工况下的试验研究。结果表明:采用的多点喷射方案大大提高了空间利用率,有效满足了引射系统小型化的要求;喷雾性能好,喷雾锥角及粒径优于设计指标要求;点火可靠性高,解决了领域内现有燃气发生器点火可靠性低的缺点;点火迅速,燃烧平稳,可实现较为均匀的出口温度场;燃气发生器工作范围较宽,能在余气系数2.52～4.34范围内稳定燃烧;高效的火焰筒内壁空气冷却方式有效保证了燃气发生器长时间工作运行。     

融合初值校准与二阶逼近的单星测频定位算法

为减小单星测频定位的误差,提出一种融合初值校准与二阶逼近的单星测频定位算法。该算法在卫星接收信号多普勒频移为零的时间点,通过测距获得卫星到定位目标的距离信息,利用距离信息修正轨道平面与定位目标的几何关系,为初值的选取提供校准手段;将校准的初值代入含二阶级数的定位方程泰勒展开式,通过较少次数的迭代得到定位目标的真实位置,从而降低定位的算法复杂度,提高定位精度。仿真结果表明,所提出的算法与多普勒单星定位算法相比,迭代次数和定位误差大幅度减小,其实现简单、计算量少、误差小,在单星定位研究领域具有较高的理论价值和实用价值。     

Study on performance degradation and failure analysis of machine gun barrel

An increase in the use of the gun barrel will cause wear of the inner wall, which reduces the muzzle velocity and the spin rate of the projectile. The off-bore flight attitude and trajectory of the projectile also change, affecting the shooting power and the accuracy. Exterior ballistic data of a high-speed spinning projectile are required to study the performance change. Therefore, based on the barrel's accelerated life test, the whole process of projectile shooting is reproduced using numerical simulation technology, and key information on the ballistic performance change at each shooting stage are acquired. Studies have shown that in the later stages of barrel shooting, the accuracy of shooting has not decreased significantly. However, it is found that the angle of attack of the projectile increases as the wear of the barrel increases. The maximum angle of attack reaches 0.106 rad when the number of shots reaches 4300. Meanwhile, elliptical bullet hole has appeared on the target at this shooting stage. Through combining external ballistic theory with simulation results, the primary reason of this phenomenon is found to be a significant decrease in the muzzle spin rate of the projectile. At the end of the barrel life, the projectile muzzle spin rate is 57.5% lower than that of a barrel without wear.     

Numerical simulation of the blast wave of a multilayer composite charge

The numerical simulation of a blast wave of a multilayer composite charge is investigated. A calculation model of the near-field explosion and far-field propagation of the shock wave of a composite charge is established using the AUTODYN finite element program. Results of the near-field and far-field calculations of the shock wave respectively converge at cell sizes of 0.25–0.5 cm and 1–3 cm. The Euler––flux-corrected transport solver is found to be suitable for the far-field calculation after mapping. A numerical simulation is conducted to study the formation, propagation, and interaction of the shock wave of the composite charge for different initiation modes. It is found that the initiation mode obviously affects the shock-wave waveform and pressure distribution of the composite charge. Additionally, it is found that the area of the overpressure distribution is greatest for internal and external simultaneous initiation, and the peak pressure of the shock wave exponentially decays, fitting the calculation formula of the peak overpressure attenuation under different initiation modes, which is obtained and verified by experiment. The difference between numerical and experimental results is less than 10%, and the peak overpressure of both internal and external initiation is 56.12% higher than that of central single-point initiation.     

Analysis of the stress wave and rarefaction wave produced by hypervelocity impact of sphere onto thin plate

Shock wave is emitted into the plate and sphere when a sphere hypervelocity impacts onto a thin plate. The fragmentation and phase change of the material caused by the propagation and unloading of shock wave could result in the formation of debris cloud eventually. Propagation models are deduced based on one-dimensional shock wave theory and the geometry of sphere, which uses elliptic equations (corresponding to ellipsoid equations in physical space) to describe the propagation of shock wave and the rarefaction wave. The “Effective thickness” is defined as the critical plate thickness that ensures the rarefaction wave overtake the shock wave at the back of the sphere. The “Effective thickness” is directly related to the form of the debris cloud. The relation of the “Effective thickness” and the “Optimum thickness” is also discussed. The impacts of Al spheres onto Al plates are simulated within SPH to verify the propagation models and associated theories. The results show that the wave fronts predicted by the propagation models are closer to the simulation result at higher impact velocity. The curvatures of the wave fronts decrease with the increase of impact velocities. The predicted “Effective thickness” is consistent with the simulation results. The analysis about the shock wave propagation and unloading in this paper can provide a new sight and inspiration for the quantitative study of hypervelocity impact and space debris protection.     

针对不同视场辅助信标的无人机目标定位方法

针对无人机在单站测角测距的目标定位过程中受无人机姿态角误差影响较大的问题,提出一种对辅助信标进行探测并与惯性传感器相结合的无人机姿态求解方法。建立基于容积卡尔曼滤波的惯性传感器姿态求解模型,采用梯度下降法对基于辅助信标的无人机位姿参数进行求解,并综合它们的结果对无人机的姿态偏差进行估计和校正,最后完成了不同视场条件下的目标定位和仿真计算。结果表明,所提方法对无人机目标定位精度有明显提高。     

The stability of the nuclear nonproliferation norm: a critique of norm-contestation theory

This article argues that the nuclear nonproliferation norm (NNPN) is a social fact with a relatively independent life of its own and that it has a powerful impact on the behavior of both nuclear-weapon states (NWS) and non-nuclear-weapon states (NNWS). It challenges the application of critical constructivist research on norms to the NNPN and the idea that its legitimacy and structural power depend on contestation “all the way down.” State and non-state actors play an important role in explaining the dynamics of the NNPN, but agential constructivism runs the danger of “throwing the baby out with the bath water,” neglecting the structural impact of the NNPN on state behavior. The article examines the limitations of norm-contestation theory, arguing that some norms are more resistant to contestation than others. The NNPN is more difficult to contest than new norms (such as the Responsibility to Protect) because it is rooted in fifty years of nonproliferation nuclear diplomacy. The US-India nuclear deal is not a case of “norm change” but a violation of the NNPN. The “core” of the NNPN has not changed since the US-India nuclear deal. The conflict confronting NWS and NNWS is about the implementation of “type 2” norms (organizing principles) and “type 3” norms (standardized procedures), and not about the “hard core” of the NNPN.     

Mirror,mirror on the wall,who is the most offensive of them all? – Explaining the offensive bias in military tactical thinking

This article explores why the offensive predominates military tactical thinking. With survey results showing an offensive bias among 60 per cent of senior Swedish officers and as many as 80 per cent in the case of the army, it is clear that this is not just a problem of the past but is equally relevant today. The article asks why there is a tendency to perceive and understand offensive tactics as the preferred choice and the way to conduct battle that should be encouraged and preferred. Drawing on existing research and the findings of a pilot study, ten propositions for why the offensive bias exists are tested using a mixed-method approach. Based on the findings, the article develops a model to understand why the offensive dominates military tactical thinking. It is found that the two key constitutive factors behind the offensive bias are military culture and education. These factors most directly and profoundly influence an officer’s identity, perceptions, and thinking. Military culture and education, in turn, work as a prism for four other factors: military history, the theory and principles of war, doctrine and TTPs, and psychological factors.     

电磁发射弹丸飞行弹道仿真

针对电磁发射弹丸飞行弹道进行仿真研究,在建立刚体六自由度飞行弹道模型的基础上,采用时频分析和涡流分析方法,建立电磁-动力学耦合模型分析弹丸出膛时由于膛内振动带来的炮口扰动,采用动网格技术建立电磁-气动耦合模型分析弹托分离产生的气动扰动,从而得到了电磁发射弹丸的飞行弹道模型。以得克萨斯大学先进技术研究所设计的IAT-HVP为例,仿真分析了弹丸以1117 m/s初速、0°射角出膛时弹丸出口扰动对弹体速度和气动特性的影响,并得到其飞行200 m的弹道曲线。仿真结果表明,受电磁发射一体化弹丸出口扰动的影响,弹体落点相比理想弹道产生了24%的偏差,其中炮口扰动引起的偏差最大,其次是弹托分离。     

超声速气流中液体横向射流一次破碎过程

发展显微成像方法获得空间分辨率为1.57 μm/pixel的近场射流瞬态图像,分析超声速气流中液体横向射流表面波演化规律。采用流体体积法获得射流的三维形态及近场流场特征,研究近场流场结构及气液作用。射流的一次破碎过程主要有表面破碎和液柱破碎。其中表面破碎由气液剪切引起的K-H不稳定主导,液柱破碎由气液加速引起的R-T不稳定主导;射流柱表面局部压力的脉动是诱导产生射流迎风面表面波并促使其沿射流方向发展的主要原因;射流柱与超声速气流作用形成背风面回流,近壁面液雾主要由表面破碎及背风面回流输运的液滴组成。