短波通信组网研究

对于短波信道,目前基本上是用于点对点的通信媒介。采用组网通信方式可以在网内选择最佳链路,克服信道不稳定、干扰大、可靠性差等不足。首先介绍了网络的拓扑结构,然后针对短波通信的特点研究了短波星形组网、树形组网和网形组网的军事应用及拓扑设计,并给出了具体的构造方法。可为短波军事通信网络系统的规划与建设提高参考。     

建筑消防给水设计中几个问题探讨

本文讨论了建筑消防给水系统在日常管理、防火检查中存在的问题,提出在消防给水设计中应采取的措施。     

近地卫星Ka频段数传链路抗雨衰ACM模式设计

针对近地卫星数传时的信道时变性和严重的Ka频段雨衰现象,采用自适应编码调制（ACM）技术能够充分利用链路资源,相对于传统的固定编码调制方式,进一步提高了链路的数据吞吐量。提出了近地卫星Ka频段数传链路ACM模式设计方法,在降雨环境下建立Ka频段数传链路模型,根据信道状况确定ACM选用模式;采用基于导频符号的最大似然信噪比估计算法结合移动平均的平滑方法实现信道估计,有效地减小了估计值的波动。仿真结果表明,无论晴天还是雨天,采用提出的卫星数传链路ACM模式设计方法,能够在保证系统可靠性的同时获取较高的数据吞吐量。     

TDS-OFDM雷达通信共享信号波形设计

在使用正交频分复用(Orthogonal Frequency Division Multiplexing, OFDM)信号的雷达通信一体化系统中,循环前缀(Cyclic Prefix, CP)和导频的存在,使得共享信号在自相关运算中出现较高的副瓣电平,严重影响雷达检测性能。针对这个问题,提出一种新的基于时域同步OFDM(Time Domain Synchronization OFDM, TDS-OFDM)的共享信号形式,该信号利用训练序列填充保护间隔,同时完成同步与信道估计,从而避免了CP副瓣和导频副瓣的出现。首先分析TDS-OFDM共享信号的模糊函数,然后通过训练序列的优化设计,有效降低TDS-OFDM信号的距离峰值副瓣,同时保持训练序列自身良好的自相关性能。理论分析与仿真表明,相对于CP-OFDM,TDS-OFDM共享信号更加适用于雷达通信一体化系统。     

Anti-follower jamming wide gap multi-pattern frequency hopping communication method

This paper deals with the follower jamming (FJ) resistance for the frequency hopping (FH) communication system over additive white Gaussian noise (AWGN) channel. Conventional FH systems are susceptible to be jammed by FJ, and multi-pattern frequency hopping (MPFH) has good resistance to FJ. To further improve the FJ rejection capability of MPFH, we propose a wide gap multi-pattern frequency hopping (WGMPFH) scheme. WGMPFH uses channels to represent messages, and the data channel and complementary channel are hopping on orthogonal frequency slots according to wide gap FH patterns. The transmitted signal lures FJ to aim at the data channel and the complementary channel is away from FJ by adopting wide gap frequency patterns. FJ does not affect the complementary channel but increases the signal energy in the data channel, thus the effect of FJ is reduced. Its bit error rate (BER) is derived under FJ and the effects of three FJ parameters (tracking success probability, jamming duration ratio and jamming bandwidth ratio) on the BER performance of WGMPFH are investigated versus the conventional FH/BFSK and MPFH system. Numerical and simulation results show that when under the worst-case FJ, the proposed WGMPFH outperforms the MPFH by about 1–3 dB and outperforms the conventional FH/BFSK by more than 4 dB. The proposed WGMPFH shows superior jamming rejection performance under FJ especially in severe signal-to-jamming ratio (SJR).     

A high performance waveform and a new ranging method for the proximity detector

Signal modulation is an essential design factor for proximity detectors and directly affects the system’s potential performance. In order to achieve the advantages of chaotic codes bi-phase modulation (CCBPM) and linear frequency modulation (LFM) simultaneously, this paper designed a waveform which combined chaotic codes bi-phase modulation and linear frequency modulation (CCBPM–LFM) for proximity detectors. The CCBPM–LFM waveform was analyzed in the aspect of time delay resolution (TDR) and Doppler tolerance (DT) based on ambiguity function (AF). Then, a ranging method, which we called instant correlation harmonic demodulation (ICHD), was presented for the detector using the CCBPM–LFM waveform. By combining time domain instant correlation with harmonic demodulation, the ICHD solved the problem caused by combination modulation and made the most of the linear frequency modulation (LFM) harmonics and the correlation of chaotic codes. Finally, a prototype was implemented and ranging experiments were carried out. From the theoretical analysis and experimental results, the proximity detector used the CCBPM–LFM waveform has an outstanding detection performance.     

并联放电等离子体合成射流激励器工作特性

等离子体合成射流激励器凭借射流速度高、工作频带宽、响应迅速等优势在高速流场主动流动控制领域具有良好的应用前景。为了克服单个激励器控制能力弱、控制范围窄的缺点,开展了并联放电等离子体合成射流激励器的研究,搭建了最多支持三路并联放电的微秒脉冲电源。测试结果表明,电源在空载及负载条件下可以实现1000 Hz稳定放电。随着放电电容的增大,放电电能的提高,等离子体电弧的温度升高,激励器腔体内气体被加热得更剧烈,产生的射流速度增大。随着工作频率的提高,激励器的击穿电压降低,放电电能减小,射流速度减小。通过对触发信号的调制,可以实现每个激励器的独立控制,使得并联式激励器具有更强的流动控制灵活性。试验结果显示,激励器工作相位与触发相位具有较好的对应关系。     

基于DSP的双伺服驱动系统

针对某型火炮伺服系统的数字化改造,设计了一种基于单片DSP的双伺服驱动系统.本设计利用电机控制专用芯片--TMS320LF2407A,独立输出两路PWM控制信号,分别驱动高低和方位两个伺服电机.功率放大电路采用工作在受限单极倍频可逆PWM控制模式下的H桥结构.试验表明,该数字伺服系统工作可靠、动态响应快、噪音低.     

外军紫外告警技术的研究现状

介绍了各国对紫外告警技术的研究情况,详细列出了美国人Hall的测量数据和美国空军使用Plexus软件计算的数据,并由此得出不同作战距离的太阳光子数,供紫外告警设备设计参考。     

新型BFRP筋增强混凝土受弯构件挠度控制

玄武岩纤维塑料增强筋（BFRP筋）的特性导致以其为增强筋的受弯构件出现裂缝后刚度降低非常明显,变形发展过快。因此,对BFRP筋混凝土梁的设计主要应根据其变形性能标准的要求来进行。为方便设计人员进行BFRP筋受弯构件设计,结合试验研究,通过对比国内外有关FRP筋混凝土梁开裂截面有限惯性矩计算模型的研究,探索出适合BFRP筋混凝土梁开裂截面有效惯性矩计算模型;通过建模分析,表明有限元计算模型和其他几种计算模型一起可以应用于BFRP筋混凝土梁直接挠度控制。推导出FRP筋受弯构件配筋率计算公式,结合直接挠度控制研究,提出通过控制跨高比限值来进行梁尺寸初选的间接挠度控制计算公式。