洁净手术室的消防安全疏散设计

结合结构及功能特点分析了洁净手术室的火灾危险性,从消防安全疏散总体要求、不同通道形式疏散设计以及疏散门设计几个方面探讨了洁净手术室的消防安全疏散设计,为其消防安全设计提供参考。     

复杂声场环境下的近场声全息技术

近场声全息对测量环境的严格要求限制了它在工程实际中的应用,特别是利用互谱法求解全惠面声压时,参考信号的获取极为关键.针对有多个噪声源同时存在的复杂声场环境,提出一种工程解决方法,利用振动信号和声源出口处的信号作为近场声全息的参考信号,在传递函数法的基础上推导出全息面上分离的复声压,由此达到复杂声场环境下的近场声全息重建...     

电磁辐射对桥丝式电火工品性能影响研究

利用传导方法研究射频对桥丝式电火工品的桥丝电阻、烤爆、迟发火以及瞎火等性能影响。研究结果表明,在10％发火功率和0．4MHz的敏感频率条件下,所研究的3种电火工品在照射1～5min后,电阻增加1.2％～7．4％,并且17．3％的试样在照射的过程中出现了烤爆;在对经过照射后的试样进行正常的发火感度试验中,发火时间显著增加,出现了不同程度的迟发火,16．9％的试样瞎火。     

基于云重心方法的海战场环境评估

针对当前海战场环境评估方法存在的问题与不足,引入云理论对其进行科学评估。首先,对云模型和云重心的评判步骤进行阐述。然后,建立海战场环境的云模型和评价指标体系,算出加权偏离度θ。最后,将结果输入云发生器得出评价结果。实验结果表明,该方法简单易行,可操作性强,为海战场环境评估提供了一种较好的途径。     

Numerical investigation of the shockwave overpressure fields of multi-sources FAE explosions

Shockwaves from fuel-air explosive (FAE) cloud explosions may cause significant casualties. The ground overpressure field is usually used to evaluate the damage range of explosion shockwaves. In this paper, a finite element model of multi-sources FAE explosion is established to simulate the process of multiple shockwaves propagation and interaction. The model is verified with the experimental data of a fourfold-source FAE explosion, with the total fuel mass of 340 kg. Simulation results show that the overpressure fields of multi-sources FAE explosions are different from that of the single-source. In the case of multi-sources, the overpressure fields are influenced significantly by source scattering distance and source number. Subsequently, damage ranges of overpressure under three different levels are calculated. Within a suitable source scattering distance, the damage range of multi-sources situation is greater than that of the single-source, under the same amount of total fuel mass. This research provides a basis for personnel shockwave protection from multi-sources FAE explosion.     

Reaction degree of composition B explosive with multi-layered compound structure protection subjected to detonation loading

The explosive reaction degree and protection from explosions are concerns in the military field.In this work,the reaction degree of the composition B explosive was investigated experimentally.Multi-layered compound structures were used as barriers to weaken the blast loads.A comprehensive experiment using a high-speed camera and image processing techniques,side witness plates,and bottom witness plates was presented.Using the experimental fragment velocities,fragment piercing patterns,and damage characteristics,the reaction degree of the explosive impeded by different multi-layered com-pound structures could be precisely differentiated.Reaction parameters of the explosive obstructed by compound structures were obtained by theoretical analysis and numerical simulations.Unlike the common method in which the explosive reaction degree is only distinguished based on the initial pressure amplitude transmitted into the explosive,a following shock wave reflected from the side steel casing was also considered.Different detonation growth paths in the explosive formed.Therefore,all these shock wave propagation characteristics must be considered to analyze the explosive response impeded by compound structures.     

电晕放电辐射场若干特性分析

为了研究电晕放电辐射场若干特性,首先进行了电晕放电时电晕电流的理论分析,研究了电晕电流的波形随电压变化情况。然后在采用针-板电极物理实验模型的基础上进行了电晕放电实验研究,分析了放电针上的充电电压对脉冲电流的影响,并确定了辐射场随传播距离的变化规律以及放电重复率随电压的变化情况。实验结果发现,当针为负极性时先发生放电,但正极性下先发生火花放电;电晕放电辐射场与距离成反比关系;放电重复率随着电压的增大而增大。     

坦克外部磁场的有限元分析

采用有限元数值计算方法,参考坦克的旋转椭球模型的计算公式,对坦克外部的磁场进行了计算机模拟计算.     

PIP工艺制备的C/SiC复合材料的氧化行为

PIP工艺制备的C/SiC复合材料中SiC基体富碳,因此增强体和基体均容易氧化。碳纤维和无涂层保护C/SiC复合材料试样在400~1300℃的氧化速率随温度升高而加快,低温为反应控制,高温为扩散控制。CVD-SiC涂层保护C/SiC复合材料和由CVD-SiC层、自愈合层、CVD-SiC层三层涂层保护C/SiC复合材料在400~1300℃的氧化先随温度升高而加快,然后减慢。三层涂层在800~1300℃有非常好的保护效果。扫描电镜照片显示自愈合层的玻璃态物质进入涂层裂纹中,填充裂纹且阻挡氧的通过,从而有良好的抗氧化保护效果。     

消防行政即时强制研究

消防行政即时强制是消防行政强制的一种,由于其适用的目的和程序与消防行政强制执行不同而具有特殊性。对消防行政即时强制的法律性质、实施条件、手段、救济等问题进行了初步探讨。