全文获取类型
收费全文 | 378篇 |
免费 | 108篇 |
国内免费 | 36篇 |
出版年
2024年 | 3篇 |
2023年 | 6篇 |
2022年 | 14篇 |
2021年 | 9篇 |
2020年 | 8篇 |
2019年 | 3篇 |
2018年 | 5篇 |
2017年 | 18篇 |
2016年 | 20篇 |
2015年 | 25篇 |
2014年 | 39篇 |
2013年 | 28篇 |
2012年 | 43篇 |
2011年 | 25篇 |
2010年 | 21篇 |
2009年 | 35篇 |
2008年 | 24篇 |
2007年 | 32篇 |
2006年 | 26篇 |
2005年 | 18篇 |
2004年 | 20篇 |
2003年 | 23篇 |
2002年 | 14篇 |
2001年 | 11篇 |
2000年 | 9篇 |
1999年 | 9篇 |
1998年 | 5篇 |
1997年 | 5篇 |
1996年 | 3篇 |
1995年 | 3篇 |
1994年 | 6篇 |
1993年 | 5篇 |
1992年 | 2篇 |
1991年 | 4篇 |
1989年 | 1篇 |
排序方式: 共有522条查询结果,搜索用时 15 毫秒
131.
本文研究将分布式双处理器控制技术应用于移动电站性能测试中,构成移动电站整机性能参数自动测试仪,该测试仪比传统测试方法提高效率8~10倍,且操作简便。 相似文献
132.
本文为在野战条件下检测雷达测距系统的性能提供一种新型微波目标信号模拟器,闸述其工作原理及功能。除在检测雷达测距系统性能上已得到实际应用外,还论述了可以进一步开发的应用项目,因为不受场地和气候条件的限制,从而获得较好的效能、效率和效益。 相似文献
133.
非线性传热条件下的内可逆卡诺热机最优性能有了一些讨论,本文将导出不可逆卡诺热泵工作于非线性传热 Q■条件下,最佳供热系数д与泵热率π的关系。据此可确定任意泵热率时所对应的供热系数界限。最后,讨论了这一关系的一些应用,所得结果包含了经典热力学及内可逆线性传热情况下的有关结论,为实际热泵设计提供新的理论依据。 相似文献
134.
于永利 《军械工程学院学报》1991,(4)
本文对内弹道多通道实验曲线的处理方法进行了较为详细的分析.充分利用多通道实验数据,得出了弹丸运动规律、弹底压力变化规律、平均压力变化规律.为进一步认识膛内现象奠定了一定的基础. 相似文献
135.
136.
对于高可靠、长寿命产品,基于性能退化数据分析可靠性是一种行之有效的技术途径。结合航空航天产品性能退化的机理与现场试验小子样的特点,建立了基于Normal-Poisson过程的性能退化模型。论文在对产品性能退化建模的基础上,结合Bayes方法给出了退化模型参数的估计算法和可靠性推断的公式,最后结合实例说明了方法的有效性。 相似文献
137.
《防务技术》2020,16(2):362-373
An increase in the use of the gun barrel will cause wear of the inner wall, which reduces the muzzle velocity and the spin rate of the projectile. The off-bore flight attitude and trajectory of the projectile also change, affecting the shooting power and the accuracy. Exterior ballistic data of a high-speed spinning projectile are required to study the performance change. Therefore, based on the barrel's accelerated life test, the whole process of projectile shooting is reproduced using numerical simulation technology, and key information on the ballistic performance change at each shooting stage are acquired. Studies have shown that in the later stages of barrel shooting, the accuracy of shooting has not decreased significantly. However, it is found that the angle of attack of the projectile increases as the wear of the barrel increases. The maximum angle of attack reaches 0.106 rad when the number of shots reaches 4300. Meanwhile, elliptical bullet hole has appeared on the target at this shooting stage. Through combining external ballistic theory with simulation results, the primary reason of this phenomenon is found to be a significant decrease in the muzzle spin rate of the projectile. At the end of the barrel life, the projectile muzzle spin rate is 57.5% lower than that of a barrel without wear. 相似文献
138.
针对电磁发射弹丸飞行弹道进行仿真研究,在建立刚体六自由度飞行弹道模型的基础上,采用时频分析和涡流分析方法,建立电磁-动力学耦合模型分析弹丸出膛时由于膛内振动带来的炮口扰动,采用动网格技术建立电磁-气动耦合模型分析弹托分离产生的气动扰动,从而得到了电磁发射弹丸的飞行弹道模型。以得克萨斯大学先进技术研究所设计的IAT-HVP为例,仿真分析了弹丸以1117 m/s初速、0°射角出膛时弹丸出口扰动对弹体速度和气动特性的影响,并得到其飞行200 m的弹道曲线。仿真结果表明,受电磁发射一体化弹丸出口扰动的影响,弹体落点相比理想弹道产生了24%的偏差,其中炮口扰动引起的偏差最大,其次是弹托分离。 相似文献
139.
140.
We consider the problem of finding the system with the best primary performance measure among a finite number of simulated systems in the presence of a stochastic constraint on a single real‐valued secondary performance measure. Solving this problem requires the identification and removal from consideration of infeasible systems (Phase I) and of systems whose primary performance measure is dominated by that of other feasible systems (Phase II). We use indifference zones in both phases and consider two approaches, namely, carrying out Phases I and II sequentially and carrying out Phases I and II simultaneously, and we provide specific example procedures of each type. We present theoretical results guaranteeing that our approaches (general and specific, sequential and simultaneous) yield the best system with at least a prespecified probability, and we provide a portion of an extensive numerical study aimed at evaluating and comparing the performance of our approaches. The experimental results show that both new procedures are useful for constrained ranking and selection, with neither procedure showing uniform superiority over the other.© 2010 Wiley Periodicals, Inc. Naval Research Logistics, 2010 相似文献