基于改进March SS算法的存储器测试技术研究

摘要：针对存储器的特点,介绍了存储器简化的功能故障模型．基于一种既可以测试静态简化故障又可以测试动态简化故障的MarchSS算法,提出了一种改进的存储器测试算法MarchSSI算法．该算法不仅能测出MarchSS算法测试的所有功能故障,而且能够覆盖MarchSS算法遗漏的故障,使算法故障覆盖率有了一定的提高．通过仿真,验证了算法的可行性．     

15cm×15cm 磁悬挂天平系统(MSBS)的电磁场分析与计算

本文采用二维电磁场有限元法及磁路的简化计算法对15cm×15cm磁悬挂天平系统（MSBS）的阻力线圈间距、磁场的分布情况进行了分析计算,并与测试结果进行了分析比较,给出了15cm×15cm磁悬挂天平系统（MSBS）的结构方案。     

NICALON SiC/Al 预制丝热膨胀特性研究

本文研究了NICALON SiC束丝纤维增强铝预制丝在15～400℃温度区间内的热膨胀特性。研究表明预制丝两次热循环后得到的膨胀曲线不一致,该曲线在15～400℃范围的平均热膨胀系数分别为3.2×10~(-6)℃~(-1)、4.1×10~(-6)℃~(-1)。本文对预制丝的热膨胀行为进行了理论分析和探讨,计算值和实验值较为符合。     

微机硬盘的维护与维修技巧

硬盘作为微机的外部存贮器是微型机不可缺少的重要组成部分,随着计算机硬件的不断发展,硬盘的性能指标也不断的发展,包括其转速、容量等.硬盘上装有拥护的操作系统,应用程序以及重要的数据,一旦硬盘出现故障,不但会使机器不能正常工作,而且会丢失重要的数据,所以掌握硬盘的维护与维修技巧是非常重要和有意义的。     

智能水雷主动干扰方法研究

针对传统的扫雷方法在清除智能化水雷引信方面存在的不足,分析了利用主动干扰信号反水雷的思路,通过分析智能引信的工作机理及在干扰背景下对目标信号的检测能力,建立了基于奈曼-皮尔逊准则的主动干扰反水雷模型.针对水雷磁引信,选择电极式电磁扫雷具为干扰源,以中型舰船为保护对象,通过计算三者的相互位置与信噪比的关系,以及水雷检测出...     

检测探头提离效应对管道漏磁检测影响分析

在管道漏磁检测中,检测探头的提离效应对管道缺陷漏磁检测性能影响较大.在对漏磁检测探头提离效应影响因素分析的基础上,分析了管道漏磁检测探头提离效应影响特性;通过建立的模拟漏磁检测探头提离效应影响分析的实验装置系统,提取了传感器、磁化器在不同提离情况下的检测信号.根据实测数据,研究了漏磁检测过程中提离值对漏磁信号的影响趋势...     

航空磁探仪目标运动分析仿真研究

针对航空磁探仪目标运动分析问题,分析了目标运动要素确定方法。首先,采用蒙特卡洛仿真和统计分析法研究了目标运动要素估计误差的分布规律;然后,结合最小二乘定位法,给出了目标运动参数及其误差的简化算法;最后,分析了影响目标运动要素解算精度的主要因素。研究结果可为磁探仪的使用、攻潜武器的选择和攻潜效果的预测提供参考。     

Effects of nano-sized aluminum on detonation characteristics and metal acceleration for RDX-based aluminized explosive

Nano-sized aluminum(Nano-Al)powders hold promise in enhancing the total energy of explosives and the metal acceleration ability at the same time.However,the near-detonation zone effects of reaction between Nano-Al with detonation products remain unclear.In this study,the overall reaction process of 170 nm Al with RDX explosive and its effect on detonation characteristics,detonation reaction zone,and the metal acceleration ability were comprehensively investigated through a variety of experiments such as the detonation velocity test,detonation pressure test,explosive/window interface velocity test and confined plate push test using high-resolution laser interferometry.Lithium fluoride(LiF),which has an inert behavior during the explosion,was used as a control to compare the contribution of the reaction of aluminum.A thermochemical approach that took into account the reactivity of aluminum and ensuing detonation products was adopted to calculate the additional energy release by afterburn.Combining the numerical simulations based on the calculated afterburn energy and experimental results,the param-eters in the detonation equation of state describing the Nano-Al reaction characteristics were calibrated.This study found that when the 170 nm Al content is from 0％to 15％,every 5％increase of aluminum resulted in about a 1.3％decrease in detonation velocity.Manganin pressure gauge measurement showed no significant enhancement in detonation pressure.The detonation reaction time and reaction zone length of RDX/Al/wax/80/15/5 explosive is 64 ns and 0.47 mm,which is respectively 14％and 8％higher than that of RDX/wax/95/5 explosive(57 ns and 0.39 mm).Explosive/window interface velocity curves show that 170 nm Al mainly reacted with the RDX detonation products after the detonation front.For the recording time of about 10 μs throughout the plate push test duration,the maximum plate velocity and plate acceleration time accelerated by RDX/Al/wax/80/15/5 explosive is 12％and 2.9 μs higher than that of RDX/LiF/wax/80/15/5,respectively,indicating that the aluminum reaction energy significantly increased the metal acceleration time and ability of the explosive.Numerical simulations with JWLM explosive equation of state show that when the detonation products expanded to 2 times the initial volume,over 80％of the aluminum had reacted,implying very high reactivity.These results are significant in attaining a clear understanding of the reaction mechanism of Nano-Al in the development of aluminized explosives.     

坦克外部磁场的有限元分析

采用有限元数值计算方法,参考坦克的旋转椭球模型的计算公式,对坦克外部的磁场进行了计算机模拟计算.     

大功率消磁线圈受力分析与计算

大功率消磁线圈在运行中会受到较强电磁力的作用,客观地分析和计算电磁力的大小及分布情况,是设计和建造大型消磁站的一项基础性的工作.文中从电磁场基本原理出发,应用张量理论分析、计算了大功率消磁线圈的受力情况,对于设计和建造大型消磁站具有参考作用.