脉压雷达信号处理仿真分析研究

针对脉冲压缩雷达,从系统仿真的角度建立了描述雷达与目标位置的三维坐标系,根据雷达信号脉冲压缩和非相参积累模型,通过计算机Matlab仿真得出了目标回波经过脉压雷达信号处理后的结果,并进一步分析了脉冲压缩和脉冲积累处理的效能。结果表明:目标回波信号通过脉冲压缩和脉冲积累处理后,显著提高了目标回波信噪比以及对目标距离估计的精度。     

高密度存储服务器高速链路设计与仿真

针对高密度存储服务器中高速链路结构复杂、信号速率高、链路长度长等特点,在高速链路PCIE3.0和SAS3.0设计过程中引入全面的信号完整性仿真。通过对高速印刷电路板设计中拓扑结构、材料类型、印刷电路板结构等关键项目进行仿真设计,获得成本最低、性能达标的最优方案;通过全链路有源仿真,预估系统性能,降低系统投产风险;通过系统实际信号测试,验证系统性能完全满足相应规范要求,仿真结果有效可靠。     

GNSS信号功率增强对调零抗干扰接收机的性能影响

由于卫星端信号发射功率小、信号传播损耗大,到达接收机的卫星导航信号极其微弱,容易被干扰。为有效应对电磁干扰的威胁,在系统层面和用户层面同时采取抗干扰措施将是一种很好的选择。建立调零抗干扰接收机抗干扰能力分析模型,并定量分析信号功率增强对调零抗干扰接收机抗干扰性能的提升效果。结果表明：信号功率每增强10 dB,接收机抗干扰能力可提升3～4 dB,但从提高接收机非极限条件下的接收性能(载噪比、测距定位精度等)的角度,信号功率增强15～20 dB时,接收性能最优。研究成果可为卫星功率增强量的优化设计以及终端抗干扰设计提供参考。     

基于SNR的烟幕干扰效果仿真

烟幕对红外等电磁波具有吸收、反射和散射特性,可导致导引头上接收的能量大大衰减,从而降低导弹的命中概率.针对外场烟幕性能测试受气象条件和环境因素的影响较大,对准确评估抗红外烟幕遮蔽性能存在较大困难的情况,结合气象条件从烟幕透过率的变化引起导引头信噪比变化的角度,建立了烟幕干扰效果的评估模型,通过计算机仿真,得出了烟幕对红外制导导弹的干扰效果.通过试验对其中的一些结论进行了实验验证,结果表明计算结果能够与实验数据较好吻合.     

Signal‐to‐interference‐plus‐noise ratio estimation for wireless communication systems: Methods and analysis

The Signal‐to‐Interference‐plus‐Noise Ratio (SINR) is an important metric of wireless communication link quality. SINR estimates have several important applications. These include optimizing the transmit power level for a target quality of service, assisting with handoff decisions and dynamically adapting the data rate for wireless Internet applications. Accurate SINR estimation provides for both a more efficient system and a higher user‐perceived quality of service. In this paper, we develop new SINR estimators and compare their mean squared error (MSE) performance. We show that our new estimators dominate estimators that have previously appeared in the literature with respect to MSE. The sequence of transmitted bits in wireless communication systems consists of both pilot bits (which are known both to the transmitter and receiver) and user bits (which are known only by the transmitter). The SINR estimators we consider alternatively depend exclusively on pilot bits, exclusively on user bits, or simultaneously use both pilot and user bits. In addition, we consider estimators that utilize smoothing and feedback mechanisms. Smoothed estimators are motivated by the fact that the interference component of the SINR changes relatively slowly with time, typically with the addition or departure of a user to the system. Feedback estimators are motivated by the fact that receivers typically decode bits correctly with a very high probability, and therefore user bits can be thought of as quasipilot bits. For each estimator discussed, we derive an exact or approximate formula for its MSE. Satterthwaite approximations, noncentral F distributions (singly and doubly) and distribution theory of quadratic forms are the key statistical tools used in developing the MSE formulas. In the case of approximate MSE formulas, we validate their accuracy using simulation techniques. The approximate MSE formulas, of interest in their own right for comparing the quality of the estimators, are also used for optimally combining estimators. In particular, we derive optimal weights for linearly combining an estimator based on pilot bits with an estimator based on user bits. The optimal weights depend on the MSE of the two estimators being combined, and thus the accurate approximate MSE formulas can conveniently be used. The optimal weights also depend on the unknown SINR, and therefore need to be estimated in order to construct a useable combined estimator. The impact on the MSE of the combined estimator due to estimating the weights is examined. © 2004 Wiley Periodicals, Inc. Naval Research Logistics, 2004     

水下声源引起的水表面横向微波的理论研究

利用水下声信号在水表面引起的水表面横向微波振幅很小的条件,将普遍的流体力学方程线性化,推导出在水下点声源的激励下,水表面产生的二维横向微波色散关系以及波的传播形式。结果表明,二维水表面的横向微波具有和一维情况类似的结果,即具有波长短、传播速度小的特点,因而可以对入射到表面的激光束进行调制,为水下声信号检测奠定了理论基础。     

基于CZT的频谱细化算法及应用

针对复杂信号频域特征提取问题,利用Delphi语言编写了Zoom-FFT和基于CZT的频谱细化方法应用软件,以某型坦克传动箱振动速度信号为例进行了对比分析,验证了算法的有效性和程序设计的正确性。结果表明：基于CZT的频谱细化方法具有运算效率高、细化效果好等优点,可以在复杂信号分析中推广应用。     

新的IFF系统及其信号检测方法

介绍了一种新型敌我识别系统Mode 5 IFF,并分析了该系统的特点及信号产生流程。通过分析Mode 5 IFF系统询问及应答信号格式,提出了基于同步脉冲相关的Mode 5 IFF信号检测方法,该方法根据Mode 5 IFF信号同步脉冲数据一致性的特点,利用同步脉冲信号与所接收到的中频信号进行相关,取相关峰值达到Mode 5 IFF信号检测的目的。最后分析了该方法在"混扰"和低信噪比条件下的信号检测效果,验证了该方法的有效性。     

基于Kalman预测的自适应线性化信号的生成方法

自旋弹体的姿态通常采用单通道控制方法进行控制。该方法中采用线性化信号对控制信号进行调制,而线性化信号采用固定频率随机相位的信号发生器产生,这就会对弹体控制产生不良的影响。提出了一种基于Kalman预测的自适应线性化信号的实现方法。该方法通过弹旋频率测定、频率的Kalman预测和信号发生器实现了线性化信号对弹旋信号的同步、自适应倍频、定步长、定幅度的信号发生功能。仿真实验证明了方的正确性,为更加合理的控制自旋导弹的姿态提供了一种有效的方法。     

基于信号仿真支撑的角度欺骗功能仿真方法

根据雷达信号仿真和功能仿真各自的优缺点,提出了一种基于信号仿真支撑的雷达角度欺骗干扰功能仿真方法。在介绍了雷达系统仿真的两种基本形式后,提出了雷达欺骗干扰功能仿真的基本思想。以交叉极化角度欺骗干扰为例,提出了雷达欺骗干扰功能仿真关键模型的建立方法,并详细说明了其实现步骤。最后进行了仿真验证,分析了功能仿真和信号仿真精度和仿真用时的差别,结果表明了所提方法的可行性和有效性。