隧道火灾快速补救方法研究

通过对多个隧道火灾事故案例及火灾特点的分析,结合我国目前铁路和公路隧道情况,提出了一种利用涡喷消防装备快速扑灭隧道火灾的方法,实践证明该方法扑灭隧道火灾快速有效。     

The next step in Somalia: exploiting victory,post-Mogadishu

From 2006 to 2011, al-Qaeda's East African proxy, al-Shabaab, served as the de facto ruling party of Somalia despite the efforts of the internationally recognised Transitional Federal Government (TFG). During these five years, a violent struggle between al-Shabaab and the peacekeeping force of the African Union Mission in Somalia (AMISOM) resulted in thousands of dead civilians, hundreds of thousands of internally displaced persons and a strategic environment inhospitable to reconciliation, recovery or development. By 2012, AMISOM was able to break the deadlock and force al-Shabaab from Mogadishu and Kismayo. In order to continue the momentum, the African Union and other partner nations must support the TFG in neutralising al-Shabaab throughout Somalia and providing good governance to its constituents. Al-Shabaab's revenue streams must be shut down and its offensive capability must be degraded while the strategic environment is shaped to ensure that conditions conducive to a revival do not exist. Failure to do so will likely see Somalia continuing to produce Islamist extremists and pirates to menace international maritime traffic in the western Indian Ocean, destabilise East Africa and adversely impact millions.     

低Ni/改性Al2O3催化剂表面性质表征

本文用氧吸附法和程序升温脱附（ＴＰＤ）法分别考察低Ｎｉ／改性Ａｌ２Ｏ３催化剂的分散度，环已烷和苯的吸附脱附性能。结果表明：该催化剂分散性好，表面至少存在两种吸附中心。苯、环已烷在该催化剂的表面上属于一级可逆吸附脱附过程，催化剂表面能量分布不均匀。     

偏磷酸铝在Cf/AL 复合材料中的应用

以高模高强石墨纤维Ｍ４０Ｊ增强铝基复合材料为研究对象,研究了真空液相压渗工艺中,偏磷酸铝粘接剂对纤维预制件抗压性能及复合材料力学性能的影响。结果表明：偏磷酸铝的含量、Ａｌ／Ｐ原子比及处理温度对预制件的抗压性能均有显著影响,加入５％偏磷酸铝粘接剂溶液的预制件,经５００°Ｃ处理后的抗压性能满足压渗要求,纤维保持了较好的平直度及分布均匀性,所制备的复合材料抗拉强度大于５００ＭＰａ,抗弯强度大于８００ＭＰａ     

气相苯加氢低Ni/改性Al2O3催化剂性能评价

通过对γ－Ａｌ２Ｏ３载体进行化学改性处理,把Ｎｉ的含量降低（在５％以内）制得气相苯加氢低Ｎｉ／改性Ａｌ２Ｏ３催化剂。考察反应条件对其催化活性影响,并对催化剂的活性稳定性、耐热性、抗毒物能力进行评价。结果表明：该催化剂的性能良好     

Shock-induced reaction behaviors of functionally graded reactive material

In this paper, the ballistic impact experiments, including impact test chamber and impact double-spaced plates, were conducted to study the reaction behaviors of a novel functionally graded reactive material (FGRM), which was composed of polytetrafluoroethylene/aluminum (PTFE/Al) and PTFE/Al/bismuth trioxide (Bi₂O₃). The experiments showed that the impact direction of the FGRM had a significant effect on the reaction. With the same impact velocity, when the first impact material was PTFE/Al/Bi₂O₃, compared with first impact material PTFE/Al, the FGRM induced higher overpressure in the test chamber and larger damaged area of double-spaced plates. The theoretical model, which considered the shock wave generation and propagation, the effect of the shock wave on reaction efficiency, and penetration behaviors, was developed to analyze the reaction behaviors of the FGRM. The model predicted first impact material of the FGRM with a higher shock impedance was conducive to the reaction of reactive materials. The conclusion of this study provides significant information about the design and application of reactive materials.     

金属泡沫断裂韧性的试验研究

金属泡沫在其实际应用中,断裂性能和断裂韧性对于承载的多孔金属泡沫有着重要的意义。基于美国试验材料学会相关标准,采用三点弯曲试样测定了铝泡沫的I型断裂韧性。研究表明,金属泡沫的断裂为脆性断裂,在裂纹尖端附近,孔壁最薄弱的区域最容易发生变形;随着进一步加载,一些孔壁发生断裂,微裂纹在断裂尖端附近出现。随着载荷的增加,主裂纹在缺口根部形成或由微裂纹合并而成,并开始在多孔结构内传播。裂纹沿着结构最薄弱处传播,并产生次生裂纹和裂纹桥。裂纹总的扩展方式还是I型断裂。根据试验P-V曲线特点,取最大载荷点对应的力与位移求解出铝泡沫的裂纹尖端临界张开位移的平均值为0.051 mm。     

谈压缩空气泡沫系统的发展与应用

压缩空气泡沫系统是一种新型、高效的灭火系统,介绍压缩空气泡沫系统的组成、工作原理、具备的优势、适用的范围及应用前景,对该系统的应用提出见解。     

聚铝碳硅烷的流变性和纺丝性研究

采用单孔纺丝装置对不同铝含量的聚铝碳硅烷(PACS)的流变性和流变性进行研究.结果表明:随着温度升高,PACS熔体的流体特性逐渐接近牛顿流体;PACS熔体粘度对温度有强烈的依赖性,其软化点在190℃～220℃范围时,其粘流活化能在190～260kJ/mol之间;当PACS的粘度在100Pa·s左右时可纺性好;铝含量对PACS的流变性能和可纺性有重要的影响,随着铝含量的增加,PACS熔体的粘度增大,因而PACS的纺丝温度更高,可纺性变差.     

光学晶体K2Al2B2O7相位匹配参量放大研究

对K2Al2B2O7（KABO）晶体的相位匹配飞秒激光参量放大（OPA）特性进行了系统的理论计算和分析。分别讨论了Ⅰ型、Ⅱ型参量放大共线以及非共线情况,计算了在不同非共线夹角下的相位匹配角度。研究结果表明：对于一定波长的抽运光,存在一定的非共线入射角对应一定波长的信号光。在KABOⅠ型参变条件下,非共线角的引入使相位匹配角增大。这对于高效率地产生脉宽极短的飞秒参量激光、扩大飞秒激光的调谐范围以及通过参量技术放大飞秒脉冲都具有重要的意义。