移动电站整机性能自动测试仪的研制

本文研究将分布式双处理器控制技术应用于移动电站性能测试中,构成移动电站整机性能参数自动测试仪,该测试仪比传统测试方法提高效率8～10倍,且操作简便。     

微波雷达目标信号模拟器及其应用

本文为在野战条件下检测雷达测距系统的性能提供一种新型微波目标信号模拟器,闸述其工作原理及功能。除在检测雷达测距系统性能上已得到实际应用外,还论述了可以进一步开发的应用项目,因为不受场地和气候条件的限制,从而获得较好的效能、效率和效益。     

Q∝T~n时不可逆卡诺热泵的最优性能

非线性传热条件下的内可逆卡诺热机最优性能有了一些讨论,本文将导出不可逆卡诺热泵工作于非线性传热 Q■条件下,最佳供热系数д与泵热率π的关系。据此可确定任意泵热率时所对应的供热系数界限。最后,讨论了这一关系的一些应用,所得结果包含了经典热力学及内可逆线性传热情况下的有关结论,为实际热泵设计提供新的理论依据。     

不确定失效阈值影响下考虑设备剩余寿命预测信息的最优替换策略

为了进一步提升设备维修决策的科学性,通过建立综合设备剩余寿命预测数据与不确定失效阈值的最优维修决策模型,实现了不可维修设备的最优替换策略.构建基于非线性Wiener过程的设备性能退化模型,并采用极大似然法估计退化模型参数;提出一种基于期望最大(Expectation Maximization,EM)算法的不确定失效阈值...     

融合跟踪系统性能的综合评估

首先通过分析融合跟踪系统的性能评估需求,并结合已有性能评估指标,制定出一组相对完备的评估指标.使用时间加权平均的方法,详细描述了各指标的定义及其计算方法;其次,基于该组指标提出了系统性能的模糊综合评价方法,说明了该评价方法的原理及其在融合跟踪系统性能评估中的具体实现.对融合跟踪系统的测试实验表明,指标体系设置合理,评估方法可操作性强.     

小子样条件下基于Normal-Poisson过程的性能可靠性评定

对于高可靠、长寿命产品,基于性能退化数据分析可靠性是一种行之有效的技术途径。结合航空航天产品性能退化的机理与现场试验小子样的特点,建立了基于Normal-Poisson过程的性能退化模型。论文在对产品性能退化建模的基础上,结合Bayes方法给出了退化模型参数的估计算法和可靠性推断的公式,最后结合实例说明了方法的有效性。     

Study on performance degradation and failure analysis of machine gun barrel

An increase in the use of the gun barrel will cause wear of the inner wall, which reduces the muzzle velocity and the spin rate of the projectile. The off-bore flight attitude and trajectory of the projectile also change, affecting the shooting power and the accuracy. Exterior ballistic data of a high-speed spinning projectile are required to study the performance change. Therefore, based on the barrel's accelerated life test, the whole process of projectile shooting is reproduced using numerical simulation technology, and key information on the ballistic performance change at each shooting stage are acquired. Studies have shown that in the later stages of barrel shooting, the accuracy of shooting has not decreased significantly. However, it is found that the angle of attack of the projectile increases as the wear of the barrel increases. The maximum angle of attack reaches 0.106 rad when the number of shots reaches 4300. Meanwhile, elliptical bullet hole has appeared on the target at this shooting stage. Through combining external ballistic theory with simulation results, the primary reason of this phenomenon is found to be a significant decrease in the muzzle spin rate of the projectile. At the end of the barrel life, the projectile muzzle spin rate is 57.5% lower than that of a barrel without wear.     

可靠度限制下相控阵雷达天线阵面T/R单元维修模型

为了描述维修活动对相控阵雷达天线阵面系统的影响,构建了以可靠度为基础的“修旧不如新”定期维修优化模型。对相控阵雷达T/R单元失效下的天线性能参数进行分析,根据指标确定系统不能正常工作的失效T/R单元阈值; 针对大部分维修活动都难以使T/R单元修复如新的事实,引入失效率递增因子,在系统一定的可靠度水平上,以相控阵雷达系统的使用可用度和维修费用率为优化决策参数,建立了系统的维修优化模型,并运用边际效能算法对系统的最佳预防换件维修周期和换件维修组数量进行求解。实例运算结果表明,该模型突破了已有模型“修旧如新”的限制条件,更符合实际,能为维修策略的制定提供理论依据。     

Some new results on the preservation of the NBUE and NWUE aging classes under the formation of coherent systems

We consider the classical problem of whether certain classes of lifetime distributions are preserved under the formation of coherent systems. Under the assumption of independent and identically distributed (i.i.d.) component lifetimes, we consider the NBUE (new better than used in expectation) and NWUE (new worse than used in expectation) classes. First, a necessary condition for a coherent system to preserve the NBUE class is given. Sufficient conditions are then obtained for systems satisfying this necessary condition. The sufficient conditions are satisfied for a collection of systems which includes all parallel systems, but the collection is shown to be strictly larger. We also prove that no coherent system preserves the NWUE class. As byproducts of our study, we obtain the following results for the case of i.i.d. component lifetimes: (a) the DFR (decreasing failure rate) class is preserved by no coherent systems other than series systems, and (b) the IMRL (increasing mean residual life) class is not preserved by any coherent systems. Generalizations to the case of dependent component lifetimes are briefly discussed.     

箭(弹)级间螺栓法兰连接结构冲击失效实验与数值仿真

基于火箭(导弹)级间螺栓法兰连接结构,简化设计并制作了一组原理性实验件,利用ABAQUS软件建立有限元模型,设计并进行了多次落锤冲击失效实验,其中包括轴向和横向两种工况,考虑了螺栓均布与非均布、螺栓直径和螺栓-栓孔间隙等不同结构特点。实验过程中采集了螺栓力时程响应数据、柱段关键点应变时程响应数据、锤头冲击力和冲击速度及连接界面开缝位移等多组数据。根据实验效果和实测数据,分析了连接结构冲击失效机理,并对比验证发现有限元模型数值模拟效果和精度与实验结果吻合较好。研究结论可为箭(弹)级间连接结构抗冲击设计提供参考。