首页 | 本学科首页   官方微博 | 高级检索  
     

FeCl3-超滤工艺处理低温低浊水的试验研究
引用本文:梁鹏,吴恬,姚吉伦. FeCl3-超滤工艺处理低温低浊水的试验研究[J]. 后勤工程学院学报, 2010, 26(4): 60-64. DOI: 10.3969/j.issn.1672-7843.2010.04.011
作者姓名:梁鹏  吴恬  姚吉伦
作者单位:后勤工程学院营房管理与环境工程系,重庆,401311
基金项目:总后专业科研经费资助项目 
摘    要:采用FeCl3-超滤工艺进行了处理实验室条件下低温低浊水的试验研究,考察了不同投加量的FeCl3对污染物的去除效果和超滤膜运行状况的影响。结果表明,FeCl3-超滤工艺处理低温低浊水的适宜投量为8mg/L,膜出水浊度小于0.2NTU,CODM。小于2.5mg/L,对CODMn和UV254的去除率分别为37.35%和51.66%,且超滤膜运行状况较为稳定。

关 键 词:超滤  FeCl3  投加量  低温低浊水

Experimental Research on the Treatment of Low Temperature and Low Turbidity Water by FeCl3-ultrafihration Process
LIANG Peng,WU Tian,YAO Ji-lun. Experimental Research on the Treatment of Low Temperature and Low Turbidity Water by FeCl3-ultrafihration Process[J]. Journal of Logistical Engineering University, 2010, 26(4): 60-64. DOI: 10.3969/j.issn.1672-7843.2010.04.011
Authors:LIANG Peng  WU Tian  YAO Ji-lun
Affiliation:( Dept. of Barracks' Management & Environmental Engineering, LEU, Chongqing 401311, China)
Abstract:The FeCl3-ultrafihration is used to treat low temperature and low turbidity water under laboratory conditions. The influence of pollutant removal and ultrafiltration operating conditions by different FeCl3 dosage is compared. The results show that the optimal FeCl3 dosage is 8 mg/L, the turbidity of water is less than 0. 2 NTU, CODMn is less than 2.5 mg/L, the removal rate of CODMn and UV254 are 37.35% and 51.66% respectively,and the ultrafihration operating conditions is under a stable status.
Keywords:FeCl3
本文献已被 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号