首页 | 本学科首页   官方微博 | 高级检索  
     

纳米二氧化硅增强硬质聚氨酯泡沫塑料的制备
引用本文:王军,高四,王亦菲,汪萍,王建华,刘永华. 纳米二氧化硅增强硬质聚氨酯泡沫塑料的制备[J]. 国防科技大学学报, 2004, 26(4): 86-89
作者姓名:王军  高四  王亦菲  汪萍  王建华  刘永华
作者单位:1. 国防科技大学航天与材料工程学院,湖南,长沙,410073
2. 中国工程物理研究院化工材料研究所,四川,绵阳,621900
摘    要:采用功率超声,将纳米二氧化硅颗粒分散到多次甲基多苯基多异氰酸酯体系内,然后与聚醚多元醇聚合制得了纳米二氧化硅增强的硬质聚氨酯泡沫塑料。SEM分析表明,纳米二氧化硅均匀分散在聚氨酯泡沫中。在较低添加量时,纳米二氧化硅使压缩强度和冲击强度有一定提高,但会引起多次甲基多苯基多异氰酸酯粘度迅速增加,从而导致发泡反应困难,当添加量为7wt%时,压缩强度和冲击强度开始下降。

关 键 词:聚氨酯泡沫塑料  纳米二氧化硅  力学性能
文章编号:1001-2486(2004)04-086-04
收稿时间:2004-02-20
修稿时间:2004-02-20

Preparation of Nano Silicon Dioxide Reinforced Rigid Polyurethane Foam
WANG Jun,GAO Si,WANG Yifei,WANG Ping,WANG Jianhua and LIU Yonghua. Preparation of Nano Silicon Dioxide Reinforced Rigid Polyurethane Foam[J]. Journal of National University of Defense Technology, 2004, 26(4): 86-89
Authors:WANG Jun  GAO Si  WANG Yifei  WANG Ping  WANG Jianhua  LIU Yonghua
Affiliation:WANG Jun~1,GAO Si~1,WANG Yi-fei~1,WANG Ping~1,WANG Jian-hua~2,LIU Yong-hua~2
Abstract:By power ultrasonic, nano silicon dioxide particles were dispersed into polyaryl-polymethylene-isocryanate(PAPI)and rigid polyurethane foams reinforced by nano SiO2 were prepared by polymerization PAPI with polyether polyol. SEM was employed to observe the structures of SiO2 filled polyurethane foam and showed that nano SiO2 particles had been dispersed uniformly in foam. Results of mechanic test show that nano SiO2 particles in low loading fraction can increase the compressed strength and impact strength of the rigid polyurethane foam. But the addition of nano SiO2 conduces to the rapid accretion of viscosity of PAPI, which makes the foam reaction difficult to set in and the impact strength decreases with the addition of 7% nano SiO2.
Keywords:polyurethane foam  nano silicon dioxide  mechanical properties
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《国防科技大学学报》浏览原始摘要信息
点击此处可从《国防科技大学学报》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号