超宽带强电磁防护能量选择表面设计

为应对强电磁脉冲对电子信息系统的威胁,设计了一种具备收发兼容特性的超宽带强电磁防护能量选择表面,有效拓展了能量选择表面的工作带宽和工作频率,可为L、S、C波段的超宽带用频装备提供不低于14 dB的防护效果。该能量选择表面是一种周期结构,每个单元包含一对箭头形结构和一个开关二极管,可根据外界辐照电磁波的能量密度自适应切换反射或透波状态,从而实现强电磁防护与工作信号收发兼容。仿真研究表明,这一新型能量选择表面在L、S、C波段的插入损耗小于1 dB,强电磁防护能力达到22 dB。在波导中对设计的样件进行了性能验证,结果显示,该样件在波导中的平均插入损耗为1 dB,防护能力达到了14 dB,初步验证了设计结构的低插入损耗和高防护特性。     

基于磁通门/GPS组合的车辆导航系统滤波技术

给出了基于磁通门/GPS组合导航系统的硬件结构图,并应用卡尔曼滤波和方差自适应滤波算法分别对GPS、磁通门单独导航定位系统进行了分散滤波,最后应用联合卡尔曼滤波器对GPS和磁通门信息进行了信息融合.并且通过实际跑车实验,验证了滤波对导航系统随机误差消除和定位精度提高的有效性.     

【专栏】飞机结构静强度应变现场测试手段展望

目前飞机结构静强度应变现场主要的测试手段为使用电阻应变计测量系统,但电阻应变计测量系统存在抗电磁干扰差、引线过多以及一致性难以保证等问题,测试效果难以保证。近年来,光纤传感以及非接触光学测量手段的迅速发展,为飞机结构静强度应变现场测试提供了多种选择。本文通过分析以数字图像相关法技术为代表的新技术的特点,如通过进行非接触操作消除安装过程中所带来的分散性误差以及不确定性,在应对某些需要定性分析的飞机静强度试验场合时可以实时给出三维应变和位移场数据,使测量技术更加直观,以及可溯源性更好、更容易保证计量特性的稳定等,对未来飞机结构静强度应变现场测试手段进行了展望,以期为相关部门和机构提供参考。     

An investigation on anti-impact and penetration performance of basalt fiber composites with different weave and lay-up modes

The woven basalt fiber composites (WBFC) and the unidirectional [0°/90°/45°/-45°]_s basalt fiber composites (UBFC) were prepared by hot-pressing. Three-point bending test, low velocity impact test, and ballistic test were performed to the prepared composites. After the tests, the specimens were recovered and analyzed for micromorphology. Three-point bending tests show that both the bending strength and stiffness of the WBFC surpass those of the UBFC. Low velocity impact test results show that the low velocity impact resistance to hemispherical impactor of the UBFC is higher than that of the WBFC, but the low velocity impact resistance to sharp impactor of the UBFC is lower than that of the WBFC. For the ballistic test, it can be found that the ballistic property of the UBFC is higher than that of the WBFC. After the tests, microscopic analysis of the specimens was applied, and their failure mechanism was discussed. The main failure modes of the UBFC are delamination and fibers breakage under the above loading conditions while the main failure mode of the WBFC is fibers breakage. Although delamination damage can be found in the WBFC under the above loading conditions, the degree of delamination is far less than that of the UBFC.     

面向作战任务的最小风险传感器调度方法

基于风险理论提出一种面向不同目标探测任务的传感器调度方法。将主动传感器辐射被截获风险和目标探测风险结合起来,建立一般目标探测框架下的传感器最小风险调度模型。分目标跟踪、目标识别和目标威胁等级评估三种情况将传感器最小风险调度模型具体化,给出不同情况下目标探测风险值的计算方法。针对模型的求解提出一种基于混沌思想、反向学习和双向轮盘赌的改进人工蜂群算法。通过仿真实验证明了模型的可行性和算法的有效性。     

柔软物体力触觉形变模型验证系统

为了验证柔性物体力-形变模型的合理性,构建了基于CC2531芯片的无线数据收发平台、力传感器测量平台和FALCON手控器位移测量平台的力-形变模型验证系统。以新鲜猪肝脏为实验对象,研究了弹性形变实验和穿刺实验的作用力与位移之间的关系;以力-形变测量数据为基础,进行了参数验证校调。仿真实验结果表明:模型中力-形变特性与实际测量值保持一致。该系统能广泛应用于柔性物体力-形变模型验证,对于促进力触觉虚拟医学仿真系统的发展具有重要意义。     

A Question of ‘Government’ Control: Afghanistan DDR Programs Since 2001

Since the fall of the Taliban in late 2001, the Islamic Republic of Afghanistan (GIRoA), the United States, the United Nations, and the International Security Assistance Force (ISAF) have funded and led three different Disarmament, Demobilization, and Reintegration (DDR) programs. Despite a significant investment in time and treasure, all of them have failed to significantly reduce the number of insurgents or arbaki (militia). This article explores why these programs failed despite incorporating ideas from the prominent DDR schools of thought. Utilizing Stathis Kalyvas’ theory of The Logic of Violence in Civil War as a lens, this article argues that GIRoA and ISAF did not have sufficient control of territory to entice insurgents or arbaki to reconcile and/or reintegrate with the government. Further, in areas GIRoA nominally controlled in northern and western Afghanistan, regional powerbrokers who controlled these areas balked at these programs.     

基于位置信息的无线传感网络路由改进

基于位置信息的无线传感器网络如果完全采用无状态的方式路由,在某些拓扑结构中存在数据不可到达的缺陷,即死亡点的问题.针对这一问题,将无线传感器网络抽象为一数学模型,在此模型的基础上,给出了问题的数学描述.经分析,提出了一种基于逃离算法的详细解决方案.对算法的性能从理论上分析得出算法没有环路,是正确可行的,而仿真结果也验证了这一点,算法的时间复杂度为O(n).     

三轴磁阻电子罗盘设计

研制了一种基于磁阻传感器和MEMS加速度计的三轴磁阻电子罗盘,包括电子罗盘的工作原理、硬件设计以及软件算法流程.航向角、俯仰角和翻滚角是罗盘系统的主要技术指标,介绍了利用该系统测量航向角的原理和在O°～360°之间显示的计算表达式.利用现场的采样数据对罗差进行校正,罗盘系统精度可从±35.7°提高至±1°左右.实验证明,该系统可用于普通导航领域.     

基于RTX的实时测控系统软件设计

从无人机半物理仿真试验的整体结构出发,针对实时测控系统的需求,采用了一种较为新颖的Windows+RTX实时性方案,完成了无人机半物理仿真试验中实时测控系统的研制.既满足了试验的实时性要求,又具有很好的用户交互特性,对测控技术的发展及其在国防科技等相关领域中的应用均有重要的参考价值.