利用波形合成技术对柴油机排气噪声实行有源控制的研究

对四冲程柴油机(4-85)的排气噪声的机理和特性进行了研究;利用波形合成的原理,控制高速信号处理芯片TMS320C25合成次级声源的声波,可以实现宽带消声．对柴油机的排气噪声进行了有源消声的初步设计．     

BDS在低轨卫星编队高精度相对轨道确定上的应用分析

分析基于北斗卫星导航系统(BeiDou satellite navigation System, BDS)的低轨卫星编队相对轨道确定问题,但由于缺乏实测数据,通过仿真实验展开研究。结果表明,500 km空域平均可视BDS卫星数约为9.7,由于地球静止轨道(GeoStationary earth Orbit,GEO)卫星和倾斜地球同步轨道(Inclined GeoSynchronous earth Orbit,IGSO)卫星的存在,亚太地区的可视BDS卫星数明显偏多。仅考虑观测噪声的影响时,基于BDS的相对定轨精度可达0.74 mm,加入星历误差的影响,对近距离编队系统的相对定轨而言,GEO卫星数米的星历误差可以忽略,但当星间距离增大到约200 km时,GEO卫星单差后的星历误差可达厘米量级,GEO+IGSO+中圆地球轨道(Medium Earth Orbit,MEO)卫星和IGSO+MEO卫星求解的相对轨道精度分别为1.09 mm和0.96 mm,GEO卫星的加入使得精度下降了13.54%。在其余误差得到有效处理后,BDS的相对定轨精度可达亚毫米量级,且无明显区域差异,GEO卫星和IGSO卫星能提高近距离编队系统的全球相对定轨精度,未来BDS将广泛应用于低轨卫星编队相对轨道确定。     

舰空导弹作战使用及指挥控制

从作战使用角度出发 ,对作战使用研究的目的、细目进行了界定 ,对作战过程中作战人员的职责、作战组织、作战实施和指挥控制问题进行了剖析 ,为最终制定作战指挥程序和编制协同任务表奠定了基础。最后指出了新的研究方向     

An investigation on anti-impact and penetration performance of basalt fiber composites with different weave and lay-up modes

The woven basalt fiber composites (WBFC) and the unidirectional [0°/90°/45°/-45°]_s basalt fiber composites (UBFC) were prepared by hot-pressing. Three-point bending test, low velocity impact test, and ballistic test were performed to the prepared composites. After the tests, the specimens were recovered and analyzed for micromorphology. Three-point bending tests show that both the bending strength and stiffness of the WBFC surpass those of the UBFC. Low velocity impact test results show that the low velocity impact resistance to hemispherical impactor of the UBFC is higher than that of the WBFC, but the low velocity impact resistance to sharp impactor of the UBFC is lower than that of the WBFC. For the ballistic test, it can be found that the ballistic property of the UBFC is higher than that of the WBFC. After the tests, microscopic analysis of the specimens was applied, and their failure mechanism was discussed. The main failure modes of the UBFC are delamination and fibers breakage under the above loading conditions while the main failure mode of the WBFC is fibers breakage. Although delamination damage can be found in the WBFC under the above loading conditions, the degree of delamination is far less than that of the UBFC.     

面向目标对峙跟踪的四旋翼协同编队控制方法

针对多四旋翼编队飞行过程中对地面目标对峙跟踪、几何队形生成、稳固保持和协同抗干扰问题,设计了一种可应对外部环境干扰和气动参数不确定性的多四旋翼主从式协同目标跟踪方法。首先,建立存在外部干扰以及参数不确定性的四旋翼运动学/动力学模型;其次,基于Lyapunov导航向量场设计领航者的对峙跟踪航迹使得领航者以固定对峙半径实现对目标的盘旋跟踪;然后,构造多四旋翼分布式位置保持控制器,为后续姿态控制器构造提供必要的期望指令;最后,针对四旋翼外部环境干扰和气动参数不确定性设计基于自抗扰控制的多四旋翼姿态跟踪控制器。仿真结果表明所提方法可以在局部智能体通信的前提下实现对地面目标的对峙跟踪,显著改善四旋翼编队系统的抗干扰能力,提升干扰环境下多四旋翼编队几何构型的稳固性。     

Formation and impact-induced separation of tandem EFPs

The formation and separation behaviors of tandem EFPs are studied by the combination of experiments and simulations. The results show that different formation and separation processes can be obtained by adjusting the double-layer liners, and simulations agree with experiments well. Then, the interaction process between the two liners is discussed in details, and the formation and separation mechanism are revealed. It can be found that there are four phases in the formation and separation processes, including impact phase, propulsion phase, slide phase and free flight phase. During the impact phase, the velocities of two liners rise in turns with kinetic energy exchange. In the propulsion phase, the axial impact becomes insignificant, but the radial interaction between two liners influences the appearance of tandem EFPs. Meanwhile, it should be mentioned that the inner surface of foregoing EFP remains to be in contact with the outer surface of following EFP in the propulsion phase, and the following one would continue to push the foregoing one for about 10μ to 20 μs, causing the velocities of following and foregoing EFPs gradually decreasing and increasing respectively. In the slide phase, an obvious relative movement occurs between the two EFPs, and there would be barely kinetic energy exchange. Then, the two EFPs separate gradually and get into the phase of free flight. Generally, if the outer and inner liners have the same thickness, the outer copper-inner copper liners form two long EFPs, the outer copper-inner steel liners become a foregoing short steel EFP and a following long copper EFP, and the outer steel-inner copper liners produce a foregoing long copper EFP and a following conical steel EFP. In addition, thickness match also has an important impact on formation appearance and separation process for both outer copper-inner copper liners and outer steel-inner copper liners. With the thickness ratio of outer liner to inner liner decreasing, the length and length-diameter ratio of both foregoing and following EFPs increase gradually.     

舰载直升机在舰艇编队对低空目标预警中的使用研究

结合水面舰艇编队对低空目标预警目前存在的问题 ,指出了使用舰载直升机对低空目标预警的必要性和可行性 ,论述了舰载直升机用于编队低空预警的优点以及配置方法 ,最后指出了舰载直升机用于低空预警时的几点注意事项