Signal‐to‐interference‐plus‐noise ratio estimation for wireless communication systems: Methods and analysis

The Signal‐to‐Interference‐plus‐Noise Ratio (SINR) is an important metric of wireless communication link quality. SINR estimates have several important applications. These include optimizing the transmit power level for a target quality of service, assisting with handoff decisions and dynamically adapting the data rate for wireless Internet applications. Accurate SINR estimation provides for both a more efficient system and a higher user‐perceived quality of service. In this paper, we develop new SINR estimators and compare their mean squared error (MSE) performance. We show that our new estimators dominate estimators that have previously appeared in the literature with respect to MSE. The sequence of transmitted bits in wireless communication systems consists of both pilot bits (which are known both to the transmitter and receiver) and user bits (which are known only by the transmitter). The SINR estimators we consider alternatively depend exclusively on pilot bits, exclusively on user bits, or simultaneously use both pilot and user bits. In addition, we consider estimators that utilize smoothing and feedback mechanisms. Smoothed estimators are motivated by the fact that the interference component of the SINR changes relatively slowly with time, typically with the addition or departure of a user to the system. Feedback estimators are motivated by the fact that receivers typically decode bits correctly with a very high probability, and therefore user bits can be thought of as quasipilot bits. For each estimator discussed, we derive an exact or approximate formula for its MSE. Satterthwaite approximations, noncentral F distributions (singly and doubly) and distribution theory of quadratic forms are the key statistical tools used in developing the MSE formulas. In the case of approximate MSE formulas, we validate their accuracy using simulation techniques. The approximate MSE formulas, of interest in their own right for comparing the quality of the estimators, are also used for optimally combining estimators. In particular, we derive optimal weights for linearly combining an estimator based on pilot bits with an estimator based on user bits. The optimal weights depend on the MSE of the two estimators being combined, and thus the accurate approximate MSE formulas can conveniently be used. The optimal weights also depend on the unknown SINR, and therefore need to be estimated in order to construct a useable combined estimator. The impact on the MSE of the combined estimator due to estimating the weights is examined. © 2004 Wiley Periodicals, Inc. Naval Research Logistics, 2004     

运载火箭姿控系统三通道Simulink建模与仿真分析

以某运载火箭为例,介绍了将姿控系统数学模型转化为Simulink三通道仿真模型的方法和过程;在仿真过程中涉及到时变系数的瞬时时间固化法,分析由此引起的计算数据局部振荡,并提出解决办法;分析了用Simulink为该大型系统建模时所遇到的代数循环问题,并加以解决。     

振荡器相位噪声对GNSS接收机载波跟踪数字锁相环性能的影响

关于振荡器相位噪声引起的GNSS接收机载波跟踪数字锁相环相位抖动,目前的解析结论仍是基于模拟锁相环的,不能说明相位抖动大小与中频积累时间的关系,因此不能有效指导高灵敏度、高精度载波跟踪锁相环参数设计.本文首先推导中频积累输出的频率白噪声、频率游走噪声序列的功率谱,然后基于数字二阶锁相环离散线性模型导出了环路相位抖动公式并进行了仿真验证,最后对公式进行了解析和数值分析.分析结果表明:频率白噪声、频率游走噪声引起的二阶载波跟踪锁相环相位抖动,均随中频积累时间单调递增,随环路带宽先递减后递增.本文推得的相位抖动公式及其随参数变化特征的分析结论,可用于具体指导GNSS载波跟踪锁相环参数设计.     

关于部分K值逻辑中正则可离函数集的极大封闭集之最小覆盖判定的一些结果

根据部分多值逻辑完备性理论,证明了当m=2时,若正则可离关系G2=G2({1,2})∪G2之关系图仅是一个回路,则T(G2)不是P k的最小覆盖成员.     

舰船动态消磁方法初步研究

传统消磁方法存在舰船系留时间长、机动性和隐蔽性差等弊端,舰船动态消磁法是解决这些弊端的有效手段。其基本思想是:使舰船慢速通过由平铺在海底的组合式消磁线圈所产生的磁场空间,从而达到在运动中消磁的目的。模型实验证明,动态消磁法能够在很短的时间内使舰船磁场得到明显的改善。     

采用摆动喷管推力矢量控制弹性弹体数学模型建立

针对摆动喷管不同于空气舵的特征,建立了摆动喷管坐标系,具体分析了单个摆动喷管产生的力和力矩,详细推导了采用摆动喷管推力矢量控制弹体弹性振动方程;同时基于小偏差线性化条件,推导了俯仰通道的姿态运动方程;以上方程可用于采用摆动喷管推力矢量控制弹体弹性计算和控制系统进一步设计的依据。     

计及励磁电流谐波的同步发电机空载电势分析

采用多回路理论,研究了同步发电机空载时计及励磁电流谐波的定子谐波电势,得到该情况下定子低次谐波电势的计算公式,并附有计算实例．     

凸集支撑函数的性质及其应用

本文讨论一个凸集C 的支撑函数的几个有用性质,并把这些性质应用于对函数次微分的研究,得到有关函数次微分的几个有趣结果。     

含Nullor网络的回路分析法

本文针对含有Nullor的网络.提出回路分析法,使有源线性网络的分析更便于进行。文中还举例说明了这种方法的应用,并验证了它的正确性。     

核动力装置主系统对蒸汽发生器给水流量的动态响应

本文把集总参数法用于堆芯、一回路和二回路,导出了主系统对蒸汽发生器给水流量丧失的动态方程组及其解析解,非常适用于运行监督性快速计算。