爆炸沸腾研究进展

分析讨论了液体过热极限、汽泡内压力等爆炸沸腾的重要参数 ,综述了三种主要实验方法 ,提出了有待进一步研究的问题 .     

有关因素对导管终点压力振幅的影响

导管-气室系统可以引发水力共振,提高脉冲射流的强度。影响水力共振的因素很多,针对一特定的水力共振系统,就导管长度、导管内径、喷嘴出口内径、调制频率、气室初始容积等因素对水力共振的影响逐一进行了计算机模拟分析,得到了各因素对导管终点压力振幅的影响趋势图,为开展实验研究提供了有力的理论指导。     

炸药装药在压剪加载下的起爆特点

进行了两类压剪加载实验：（１）利用石英的平面正碰撞产生压剪加载的实验,采用电磁质速法测试装药试件内部不同质点的运动情况,分析炸药装药中发生化学反应的可能性;（２）在压剪炮上采用平行倾斜碰撞产生压剪加载的实验,观测炸药装药爆炸的可能性。由实验可以看出：在亚爆轰状态的压缩加载应力条件下,剪切的联合作用对炸药的起爆起到敏化作用,适当比例的压剪加载造成更加敏感的炸药起爆响应。文中给出了起爆响应规律和响应机制的实验分析。     

Design optimization for a launching system with novel structure

A launching system with novel structure using optimization method is investigated to improve the muzzle velocity of guns in this article. This system has two tandem chambers of which the front one is ignited first and the other is ignited after a while. The launching process of this novel system is modelled and a series of different schemes are simulated, to discover the interior ballistic performance of this novel launching system. In order to obtain the optimal loading conditions, an optimization model combined with the combustion model is established. The optimal schemes can improve the muzzle velocity by 20.6% without changing the parameters of barrel. It means that this novel launch system could improve the interior ballistics performance significantly and it still has considerable potential to be ameliorated.     

定性测量与定量测量火炸药静电感度的对比分析

采用先进测试系统,对氮化铅、硝化棉、梯恩梯和黑索金火炸药静电感度分别进行了定性测量和定量测量,得出了相对静电感度值和实际静电感度值,并对其进行了对比分析。     

饱和蒸气比热为负的讨论

本文由热力学理论定量指出,只要两相平衡的饱和蒸气比热为负,饱和蒸气经绝热膨胀后成过饱和蒸气,并讨论了饱和蒸气比热为负的条件。     

爆炸危险环境建筑物防雷设施选择及布置

爆炸危险环境建筑物防雷由于其“特殊性”倍受电气工程技术人员关注。结合相关雷电理论，从接闪器、引下线、接地装置几个方面对爆炸危险环境建筑物防雷设施选择和布置进行了论述。     

溅板式层板喷注单元燃烧特性数值分析

为了获得喷注单元结构参数对喷注器燃烧特性的影响规律,利用数值分析方法对单喷嘴溅板式层板喷注单元气-气燃烧特性进行研究,考察燃烧室特征长度及出口层喷嘴宽度对气氧/甲烷流动及燃烧特性的影响。在求解气-气燃烧流场方面,采用带化学反应的湍流N-S方程进行描述,其中化学动力学反应模型采用简化的单步9组分模型。研究结果表明:燃烧室特征长度的增大有利于特征速度效率的增加;该条件下采用溅板式层板喷注单元所对应的燃烧室特征长度约为600 mm。对比分析发现,出口层喷嘴宽度取0.15 mm时,水组分摩尔分数与热力计算值差别最大;当其值取1.05 mm时,燃烧室头部区域截面温度上升最快,取0.45 mm时上升最慢。总的来说,出口层喷嘴宽度取0.75 mm时,燃烧长度最短,燃烧效率最大。     

基于混响室的雷达瑞利杂波模拟研究

为应对复杂电磁环境下雷达应用需求,提出一种基于混响室的雷达杂波模拟方法,利用电磁仿真软件FE—KO构建了混响室模型,分析了搅拌器控制与接收响应周期性的关系,通过随机控制混响室搅拌器在混响室内模拟了具有瑞利分布的杂波信号．实验结果显示,本实验数据分布曲线与瑞利分布曲线有良好的拟合性．     

Prediction of concentration of toxic gases produced by detonation of commercial explosives by thermochemical equilibrium calculations

An adverse effect resulting from explosive mine blasts is the production of toxic nitrogen oxides (NO and NO₂) and carbon monoxide (CO). The empirical measurements of the concentration of toxic gases showed that it depends not only on the composition of an explosive and properties of its ingredients but also on several other parameters, such as volume of blasting chamber, explosive charge mass and design, confinement characteristics, surrounding atmosphere, etc. That explains why measured concentrations of toxic gases reported in literature significantly differ.In this paper, we discuss the possibility of theoretical prediction of the concentration of toxic gases by thermochemical equilibrium calculation applying two models: ideal detonation model and deflagration model. It can be demonstrated that thermochemical calculations can provide a good estimation of the measured concentrations and reproduce experimentally obtained effects of additives on the production of toxic gases. It was also found that the ideal detonation model applies to heavily confined explosive charges, while the deflagration model is more suitable for low detonation velocity explosives with light confinement.