光纤陀螺温度场分析及结构优化设计

从导热微分方程出发,建立了光纤陀螺温度场有限元模型,对模型进行了稳态温度场和瞬态温度场仿真分析。利用铂电阻测温电路对仿真结果进行实验验证,两者相对误差小于3%,证明仿真分析的结果是正确和有效的。针对光纤环温度场分布不均匀的情况,对光纤陀螺结构进行了优化设计。光纤陀螺在25℃环境中稳定工作时,稳态温度场分析结果表明,优化设计后光纤环最高与最低温度差为0.05℃,较优化前的0.19℃减小了73.7%;将陀螺置于60℃环境且处于非开机状态时,10min瞬态温度场分析结果表明,优化设计后光纤环最高与最低温度相差0.11℃,较优化前的0.19℃减小了42.1%。     

A NEW STANDARD FOR PREEMPTIVE MILITARY ACTION AGAINST WMD THREATS

International law clearly requires an imminent threat of attack as a justification for the preemptive use of military force. However, the standard definition of an imminent threat was derived centuries before the development of nuclear, chemical, or biological weapons or ballistic missiles and other delivery systems that can reach their targets in a matter of minutes. Any use of force to alleviate threats posed by weapons of mass destruction (WMD) prior to tactical warning of the actual launch of such weapons falls into the legally and ethically controversial category of “anticipatory self-defense,” leaving decision makers potentially liable to prosecution for war crimes. Effective and ethical enforcement of nonproliferation therefore demands a standard for imminence of threat broad enough to allow military action as a last resort but sufficiently restrictive to prohibit indiscriminate action against suspected WMD programs. Following a critical review of selected literature and cases on preemption, the author proposes a new standard for preemptive military action: the existence of operational WMD, or a clandestine program to develop WMD, in contravention of international law. The author discusses the implications of this new proposed standard, which at the time of writing would permit preemptive attack against WMD-armed terrorist groups but prohibit it against all states except Iran and possibly North Korea.     

Contents and Author Index,Volume 20, 2013

The United States has multiple nuclear detection initiatives to secure against a terrorist nuclear attack, including the Container Security Initiative, installation of radiation detectors at U.S. border points of entry, and establishment of the Domestic Nuclear Detection Office (DNDO). The current nuclear detection system architecture falls short of being able to reliably catch fissile nuclear material in transit, specifically shielded Highly Enriched Uranium (HEU) and Plutonium (Pu), both within the US and abroad. Checkpoints at border crossings can be circumvented, and no adequate system is under development to deter the transport of fissile materials. Using nuclear link-budget calculations, we show why a network relying primarily on handhelds, fixed detectors, and portals is not sufficient. We examine the technical, economic, and operational feasibility of a comprehensive national network incorporating in-vehicle detectors to reliably detect and deter the transport of fissile material inside the vehicle itself.     

建筑物内部电场强度分布特性数值模拟研究

为解决建筑物内部空间电场强度分布难以量化的问题,采用时域有限差分（FDTD）法,对以平面波为激励源,二阶Mur收边界条件的闭合规则建筑物、非规则加窗建筑物和含钢筋非规则加窗建筑物3种模型结构内部电场强度分布特性进行模拟,并通过FEKO软件对计算结果的有效性进行验证。结果表明：普通混凝土材质的建筑物对平面波电场几乎无屏蔽效能;吸波混凝土材质的建筑物对平面波电场的屏蔽效能也较为有限,且随激励源频率的增加,在建筑开窗区域附近的谐振性增强,屏蔽性减弱;通过对植入钢筋墙体建筑物采用细线FDTD法的场强分布计算,证明金属钢筋可提高建筑围护结构的屏蔽效能。     

瞬态高强加热条件下含湿多孔介质传热传质模型研究

提出了瞬态高强加热下含湿多孔介质传热传质的新模型,模型包括的水分种类齐全、水分迁移机制全面,假设条件相对较少,考虑了非Fourier传热效应和非Fick传质效应。新模型通过具体的分区分析得到简化并更加实用。     

数值模拟金属靶抗侵彻中的网格密度影响研究

在数值模拟中,有限元网格的数量对计算结果和计算成本都有较大的影响。采用MSC.Patran建立了弹体侵彻金属靶板的计算模型,并利用MSC.Dytran对所建模型进行了计算;结合相关的理论,对不同网格密度划分的有限元模型的计算结果进行了分析,并和实验进行了对比,得到了数值模拟弹体侵彻金属装甲中靶板的最佳网格数量。当网格无因次量μ=0.10时,所得到的数值模拟结果与实际吻合得较好:当厚度方向的网格数取为12个时,文中所采用的模型能较好地模拟弹体对靶板的侵彻效果。     

开流形的曲率与拓扑

应用比较几何的方法研究了完备非紧且具有特定曲率条件的黎曼流形,证明了在一定Pinching条件限制下,流形具有有限拓扑型或者微分同胚于Rn。     

一种新的基于方向导数的二维自适应网格生成算法

结合形变原理及网格迭代思想,利用方向导数计算控制函数,提出一种新的二维空间自适应网格生成算法。数值实验表明,该算法能较好地适应解函数的空间剧烈变化。与其他自适应算法比较,其主要优点是该算法逻辑简单,避免了解网格偏微分方程,节约了网格计算时间。     

几何非线性机械臂有限段传递矩阵法

提出了几何非线性柔性机械臂动力学有限段传递矩阵建模方法,该方法既保留了有限段法自动计及几何非线性和动力刚化的优势,又保留了传递矩阵法建模的方便灵活.算例表明,计算时间与自由度成正比,在已知运动规律的情况下,可直接求得所需的驱动力矩,反之亦然.该方法无需建立系统总体动力学方程,易于工程技术人员掌握,具有一定实用价值.     

基于GA的模糊PID控制在质量矩导弹系统上的应用

针对三轴稳定的质量矩导弹姿态控制系统,提出了一种基于遗传算法进行参数寻优的模糊PID控制方法。在建立姿控系统数学模型的基础上,首先设计了姿态控制的优先级函数,然后根据实际的姿态控制系统,设计了遗传算法的性能指标函数和具体的优化策略,最后给出了模糊PID控制器的设计思路。仿真结果说明了该方法的有效性。