短脉冲激光作用下爆发沸腾的温度及汽泡行为研究

采用短脉冲激光加热浸没在丙酮液池的铂薄膜电阻的方法,以及高压电火花单次放电高速照相技术,在国内首次建立了超急速爆发实验台,达到了微秒级的温度频响和2×106帧/s的高速照相.研究发现,随着激光热流密度增加,试件表面温度快速升高到一饱和值,与过热液体的动力学理论极限温度非常接近.拍摄到了与常规沸腾很不相同的蘑菇云式爆发沸腾照片.试件表面及临近表面的微薄液层内瞬间爆发生成大量大小相当的细小汽泡,汽泡脱离直径远低于经典Fritz公式计算值,上浮速度先快后慢.     

基于ANSYS／LS—DYNA的电子装备爆炸冲击振动损伤建模研究

针对电子装备爆炸冲击振动损伤问题，设计了损伤模拟的基本方案；采用ANSYS／LS—DYNA建立了二维“爆炸源-地面-弹性体-电子装备”模型；通过模型试验，获得了与实际爆炸冲击振动特性相吻合的加速度、位移和应力等数据。     

聚能射流形成过程的理论建模与分析

分析了聚能射流的形成过程,并对其中的各阶段进行了详细建模。在模型中考虑了炸药爆轰、金属的驱动、药型罩压垮以及射流和杵体的形成过程。采用该模型对某一聚能装药结构进行了计算,计算结果表明:药型罩顶部和底部微元的压垮速度较小,在射流头部形成反向速度梯度,与试验数据吻合较好。该模型对于多级侵彻战斗部的工程设计与侵彻参数的计算具有一定的参考价值。     

Countering the effects of IED systems in Afghanistan: an integral approach

The current approach to countering the threat of improvised explosive devices (IEDs) in Afghanistan has met with limited success. The relative lack of success may be in part because the current approach is not holistic and discounts the social systems that foster the IEDs. Insurgents are using IEDs as a tool to further their strategic aims, but the coalition and to a lesser extent the Government of the Islamic Republic of Afghanistan (GIRoA) are attacking the IEDs as if they are an end in and of themselves. Combining network disruption with information change maximizes the opportunities for mitigating the IED threat. More specifically, to mitigate the IED threat requires disrupting the social and economic systems associated with IEDs, and at the same time providing alternative economic opportunities and improving rule of law and governance at the local level. In other words, counter-IED (C-IED) must be Counter-Insurgency (COIN) centric to be successful. This paper reviews the current state of C-IED efforts, identifies five main problems with the current approach, and suggests changes to reduce or mitigate the IED threat in Afghanistan.     

子母式穿甲弹子弹发射过程研究

对子母式穿甲弹子弹的发射过程进行详细的分析,得出了子弹长度与子弹飞离母弹速度的关系、子弹长度与火药燃烧率的关系、子弹长度与母弹弹头部发射孔内最大压力的关系以及子弹的长度与子弹发射所需时间的关系,为子母式穿甲弹设计提供了依据。     

结构设计对混响室场性能影响的仿真研究

通过仿真计算,分别研究了尺寸比例设计对混响室场均匀性的影响和体积变化对混响室电场强度大小的影响。数据结果表明：混响室内工作区域的场均匀性随着混响室长／宽比值增大而变差,且为获得场均匀性较优的测试环境,长宽比例应〈2。同时证明了混响室存在一临界体积上限,小于临界体积上限时,随着体积的增大,室内的电场强度逐渐减小,场均匀性逐渐提高;达到临界体积上限后,室内的场均匀性开始变差,混响室逐渐丧失对电磁波的混响作用。通过仿真计算得出混响室模型临界体积上限为10^4m^3。     

命中角对防护结构口部爆炸毁伤影响的数值分析

为研究装药命中角对防护结构口部爆炸毁伤的影响规律,对直墙拱结构进行了一系列爆炸模拟分析,得到了直墙拱结构拱顶、拱脚和直墙底3个位置的爆炸应力和位移时程曲线。通过分析这3个位置的应力峰值和位移峰值,发现随着装药命中角的增大,拱顶处竖直方向荷载减小,而拱脚处水平方向荷载增大;随着装药命中角的增大,拱顶处竖直方向位移变形减小,而拱脚处水平方向位移变形增大。模拟分析得到的命中角对防护结构口部爆炸毁伤的影响规律,可供防护工程设计时参考。     

Study of nano-nitramine explosives: preparation,sensitivity and application

Nano-nitramine explosives (RDX, HMX, CL-20) are produced on a bi-directional grinding mill. The scanning electron microscope (SEM) observations show that the prepared particles are semi-spherical, and the narrow size distributions are characterized using the laser particle size analyzer. Compared with the micron-sized samples, the nano-products show obvious decrease in friction and impact sensitivities. In the case of shock sensitivities, nano-products have lower values by 59.9% (RDX), 56.4% (HMX), and 58.1% (CL-20), respectively. When nano-RDX and nano-HMX are used in plastic bonded explosives (PBX) as alternative materials of micron-sized particles, their shock sensitivities are significantly decreased by 24.5% (RDX) and 22.9% (HMX), and their detonation velocities are increased by about 1.7%. Therefore, it is expected to promote the application of nano-nitramine explosives in PBXs and composite modified double-based propellants (CMDBs) so that some of their properties would be improved.     

柴油机超小型水滴形预燃室的研究

针对12V180柴油机原球形预燃室喷嘴因热负荷过大而产生热裂和断裂脱落的问题,进行了理论分析和实验研究,提出了一种新型的预燃室-超小型水滴形预燃室．实验证明使用该预燃室,可以大大降低喷嘴的热负荷,提高喷嘴使用的可靠性．     

某型枪弹火药性能对内弹道性能影响试验研究

通过对某型枪弹 (如经过技术处理的正常弹、减量弹、加温弹、干燥弹及受潮弹 )初速和最大膛压的测定 ,得出火药的药量、初温及挥发份对内弹道性能 (如膛压、初速 )有较大影响 ,因此 ,必须严格控制弹药的储存条件及装药量。