粉尘爆炸事故预防及其扑救对策研究

可燃粉尘爆炸是危害人类生产生活的一类主要事故。要有效预防粉尘爆炸事故造成的危害，准确掌握其爆炸原理，研究其爆炸特性是非常必要的。探讨了粉尘爆炸的基本特征，研究了粉尘爆炸的条件和机理及影响粉尘爆炸的因素。详细论述了粉尘爆炸火灾的特点及其危害。研究了预防粉尘爆炸及降低粉尘爆炸破坏作用的对策，并指出了在灭火战斗中应注意的问题。     

The building evacuation problem with shared information

In this article, the Building Evacuation Problem with Shared Information (BEPSI) is formulated as a mixed integer linear program, where the objective is to determine the set of routes along which to send evacuees (supply) from multiple locations throughout a building (sources) to the exits (sinks) such that the total time until all evacuees reach the exits is minimized. The formulation explicitly incorporates the constraints of shared information in providing online instructions to evacuees, ensuring that evacuees departing from an intermediate or source location at a mutual point in time receive common instructions. Arc travel time and capacity, as well as supply at the nodes, are permitted to vary with time and capacity is assumed to be recaptured over time. The BEPSI is shown to be NP‐hard. An exact technique based on Benders decomposition is proposed for its solution. Computational results from numerical experiments on a real‐world network representing a four‐story building are given. Results of experiments employing Benders cuts generated in solving a given problem instance as initial cuts in addressing an updated problem instance are also provided. © 2008 Wiley Periodicals, Inc. Naval Research Logistics, 2008     

基于支持向量机的功率变换器开关管开路故障诊断

提出一种基于支持向量机的功率变换器开关管开路故障诊断方法。利用支持向量机建立分类模型,模型以相电流功率谱为输入量,7种故障状态为输出量,选用高斯核,使用基于二叉树分类器的分类算法。将诊断结果与基于BP神经网络的诊断结果进行比较,结果表明基于支持向量机的分类器在功率变换器开关管开路故障诊断中具有更高的准确率和更好的泛化能力。     

某型非圆截面布撒器气动特性计算

飞机干扰条件下的非圆截面布撒器的气动力计算是新型航空布撒器研制中的关键技术之一.对伍德沃德提出的面元法加以改进,用改进的面元法计算了在飞机干扰下某型非圆截面布撒器的气动力,与无干扰条件下的计算结果进行了比较,并作了简要分析.     

Effect of wave shaper on reactive materials jet formation and its penetration performance

Wave shaper effect on formation behavior and penetration performance of reactive liner shaped charge (RLSC) are investigated by experiments and simulations. The reactive materials liner with a density of 2.3 g/cm³ is fabricated by cold pressing at a pressure of 300 MPa and sintering at a temperature of 380 °C. Experiments of the RLSC with and without wave shaper against steel plates are carried out at standoffs of 0.5, 1.0, and 1.5 CD (charge diameter), respectively. The experimental results show that the penetration depths and structural damage effects of steel plates decrease with increasing the standoff, while the penetration depths and the damage effects of RLSC without wave shaper are much greater than that with wave shaper at the same standoff. To understand the unusual experimental results, numerical simulations based on AUTODYN-2D code are conducted to discuss the wave shaper effect, including the propagation behavior of detonation wave, the velocity and temperature distribution of reactive jet, and penetration depth of reactive jet. The simulations indicate that, compared with RLSC without wave shaper, there is a higher temperature produced inside reactive jet with wave shaper. This unusual temperature rise effects are likely to be an important mechanism to cause the initiation delay time of reactive jet to decline, which results in significantly decreasing its penetration performance.     

2014—2016年FY-3C与COSMIC掩星电离层特征参数的比较

利用由FY-3C和COSMIC两个全球导航卫星系统无线电掩星任务提供的2014—2016共3年的电离层电子密度廓线，基于时间间隔7.5 min、经纬度间隔2.5°的时空匹配窗口，对两个掩星任务的电离层峰值密度（NmF2）和峰值高度（hmF2）进行了比较。结果表明：由两个任务得到的特征参数相关性良好，各年之间相关性水平基本稳定，其中各年NmF2和hmF2相关系数的平均值分别为0.87和0.75；FY-3C的特征参数相对于COSMIC的偏差很小，各年NmF2的绝对偏差均值和相对偏差均值分别不超过±0.25×10⁵ el/cm³和±15.0%，hmF2的绝对偏差均值和相对偏差均值分别不超过±7.00 km和±1.80%。此外，由两个任务得到的特征参数在空间上均表现出赤道及低纬地区数值较高且呈“条带状”分布的特点，且两个任务都监测到了2016年相对于2014年和2015年NmF2和 hmF2均存在显著下降的现象     

Analytic solution for the nucleolus of a three‐player cooperative game

The nucleolus solution for cooperative games in characteristic function form is usually computed numerically by solving a sequence of linear programing (LP) problems, or by solving a single, but very large‐scale, LP problem. This article proposes an algebraic method to compute the nucleolus solution analytically (i.e., in closed‐form) for a three‐player cooperative game in characteristic function form. We first consider cooperative games with empty core and derive a formula to compute the nucleolus solution. Next, we examine cooperative games with nonempty core and calculate the nucleolus solution analytically for five possible cases arising from the relationship among the value functions of different coalitions. © 2010 Wiley Periodicals, Inc. Naval Research Logistics, 2010     

辐射传热时活塞式气缸中加热气体的最大膨胀功

对热辐射传热定律q∝Δ(T4)下,给定初态内能、体积,末态体积以及过程时间时,加热气体膨胀的最优构型进行了研究,利用最优控制理论得出最大膨胀功输出时膨胀的最优构型由两个瞬时绝热分支和一个E-L分支组成的结论.给出了各分支之间转换点参数的求解方法及最优构型的数值算例,最后将线性唯象传热定律、牛顿传热定律、平方传热定律、立方传热定律和辐射传热定律下加热气体膨胀的最优构型进行了比较.结果显示,随着传热指数的增加,理想气体的内能呈现出明显的整体增加趋势,而体积则呈现出明显的整体减小趋势.     

机器翻译中语义块汉英变换处理

首先解释了要素句蜕的内涵,同时介绍了HNC理论的句蜕观,并依据HNC句类理论提出了汉英机器翻译中,要素句蜕处理的具体规则,还结合真实语料进行了验证。     

基于AdaBoost-SVM的P2P流量识别方法

针对传统的P2P流量识别技术存在识别率低和误判率高的缺点,将机器学习中Ada Boost算法的良好分类能力和SVM的泛化能力结合起来,提出一种基于Ada Boost-SVM组合算法的P2P网络流量识别模型,将SVM作为Ada Boost的基分类器,运用最小近邻法计算支持向量与训练集的样本间的距离实现分类进行P2P流量识别。最后,以4种P2P流量数据为研究对象在MATLAB上进行仿真,仿真结果表明,提出的Ada Boost-SVM的组合算法在P2P网络流量的分类性能和分类准确率上都优于单纯的Ada Boost和SVM,组合算法的P2P流量平均识别率高达98.7%,远高于Ada Boost和SVM的识别率。